Sailing Vessel Triteia - The Iron Genny - Part III - Episode 8 - Hooking Up New Diesel Engine

On this episode of Sailing Vessel Triteia I dive below to check the propellers position before setting the engine in its final spot and drilling the new holes in the engine bracket. I then continue on hooking up the control cables, exhaust system and fuel lines and finally hooking up the water intake to the broken seacock. I watched the sea flow into my boat as I switched from the old to the new hoses, which is a very unsettling feeling even for just a moment. This is part 3 of 4 episodes of the engine installation. The next episode will show me installing the control panel and batteries, finishing up the last few things before attempting to start the engine for the first time. I hope you enjoy this episode and if you do please give it a “thumbs up”! I have began uploading “Patreon Only” videos to my Patreon page for Patrons donating a dollar or more a video if you would like to see clips that did not make it into the episodes. https://www.patreon.com/sailorjames Fair Winds, Sailor James - ⚓- Stuff I used in this video: Marine Diesel Engines: Maintenance, Troubleshooting, and Repair http://amzn.to/2z23o3j Fuel Tank Fill Hose USCG Type A2 - Series 350 1-1/2" Wire Reinforced http://amzn.to/2gy2VPq LarryB's Trident Barrier Lined 5/16" Marine Grade Biodiesel Ready Fuel hose, per foot http://amzn.to/2xzvmar 3" inch ID MARINE WET EXHAUST HOSE CORRUGATED HARDWALL WIRE REINFORCED http://amzn.to/2hBxrHS - ⚓- Alberg 30’s have long been known and respected as blue water boats, from Yves Gelinas’ Jean-Du-Sud to being featured in John Vigor’s “Twenty Small Sailboats to Take You Anywhere”. Now I am the proud owner of Hull #55! Come along with me as I refit her and take her sailing in preparation for my circumnavigation in a few years time! Follow on Instagram: http://instagram.com/james.the.sailor And of course please subscribe to my videos at: https://www.youtube.com/sailorjames