The servo is hooked up to the Arduino via pin 9. I've uploaded one of the example sketches you get with Arduino ISP called 'Servo Sweep'. The servo is powered by a 24 volt rough DC supply as you can see in the video. The 20mm steel boss was machined and bored out concentrically to 8.0 mm. A 5.0 mm hole was drilled in the side of the boss and tapped to take an M6 grub screw. The boss was welded into a piece of 1/8 inch steel plate to make the servo arm.

0

0

0

855

My website: https://www.nomadboatbuilding.com Instagram: https://www.instagram.com/nomadboatbuilding/ It's not about the money but living isn't free... Here are some ways you can support this channel. Get 5% off TotalBoat products here: https://www.totalboat.com/?sca_ref=3715732.xvvNNHFDPJ Get 10% off Starbond Adhesives. Use the Coupon code NOMAD10 Shop here: https://starbond.com/discount/NOMAD10 Buy some merch: https://www.nomadboatbuilding.com/shop/ Support these videos with monthly or annual pledges at Patreon: https://www.patreon.com/nomadboatbuilding Or make a one time donation: https://www.paypal.com/paypalme/nomadboatbuilding

0

0

0

782

Passeio a cidade de Feliz voltando com muita chuva

0

0

0

14

0

0

0

0

1,827

🔴 Full Video Here: https://youtu.be/lUOhTHkHxGM 👻 If you dare. We Spent The Night with the dead at the Old Washo Club in Virginia City, Nevada. We were genuinely freaked out and saw and heard things we cannot explain. #shorts

0

0

0

2,343

0

0

0

0

312