The servo is hooked up to the Arduino via pin 9. I've uploaded one of the example sketches you get with Arduino ISP called 'Servo Sweep'. The servo is powered by a 24 volt rough DC supply as you can see in the video. The 20mm steel boss was machined and bored out concentrically to 8.0 mm. A 5.0 mm hole was drilled in the side of the boss and tapped to take an M6 grub screw. The boss was welded into a piece of 1/8 inch steel plate to make the servo arm.

0

0

0

855

0

0

0

0

17

#alaskankleekai #dogs #husky #boatdogs

0

0

0

172

Captain Nick preparing for his Transpacific sail

0

0

0

563

Saturday Sail on #gecko40 . Easy 6kts in 10kts of wind. ▫️ We can't go far with the lock down restrictions, just out and back, and it's tempting to keep going to Mallorca 😉. ▫️ Anyway, all good as it's working. The numbers are coming down and we are allowed to move around Catalunya from tomorrow, so we are planning a trip to the Ebro Delta. ▫️ Head to 'kats.co/gecko' for more info on Gecko and 'kats.co/n40' for our owner's review. Have a good one! ▫️ #multihulls #catamaransailing #sailing #catamarans

0

0

0

100

0

0

0

0

99