The servo is hooked up to the Arduino via pin 9. I've uploaded one of the example sketches you get with Arduino ISP called 'Servo Sweep'. The servo is powered by a 24 volt rough DC supply as you can see in the video. The 20mm steel boss was machined and bored out concentrically to 8.0 mm. A 5.0 mm hole was drilled in the side of the boss and tapped to take an M6 grub screw. The boss was welded into a piece of 1/8 inch steel plate to make the servo arm.

0

0

0

855

0

0

0

0

1,033

Knowing how to tie a Bowline Around the Waist is essential for surviving at sea. In this video, one of our trainees demonstrates the knot in a real-life practice scenario, showing how it can be used safely and effectively. ⛵⚓ This skill is invaluable not only for sailing emergencies but also for rescue situations on land, like during earthquakes or disasters. Learn, practice, and stay safe! #bowline #bowlinearoundwaist #sailingknots #rescueknots #safetyfirst #seamanship

0

0

0

41

Nothings worse than a performance car where launch control has a convoluted process. Chevy made it easy with these simple steps! It is the same process in the new #z06 #z06corvette #chevy #shorts #caroftheday #c8 #c8corvette #loudcars #carshorts #auto #launchcontrol #2023corvette

0

0

0

6,693

0

0

0

0

1,119