The servo is hooked up to the Arduino via pin 9. I've uploaded one of the example sketches you get with Arduino ISP called 'Servo Sweep'. The servo is powered by a 24 volt rough DC supply as you can see in the video. The 20mm steel boss was machined and bored out concentrically to 8.0 mm. A 5.0 mm hole was drilled in the side of the boss and tapped to take an M6 grub screw. The boss was welded into a piece of 1/8 inch steel plate to make the servo arm.

0

0

0

855

0

0

0

0

67

0

0

0

0

2,941

FREE GIFT to you, CLICK HERE: https://bit.ly/3uSmHhI Subscribe to our YouTube Channel at https://bit.ly/3ta7Hv6 From the Arctic to the Aeolian islands: Sailing around the world with a catamaran. Recommended Books: https://amzn.to/485q9DG 'Sailing a Serious Ocean' https://amzn.to/3UumDzy 'The Complete Sailor' In full transparency, please note that the links in this video description may be affiliate links, which means I may earn a commission if you make a purchase through these links. You don't pay more when using these links, and any earnings help to support this channel. I only recommend products or services I believe will add value to my audience. I am disclosing this in accordance with the Federal Trade Commission's 16 CFR, Part 255: "Guides Concerning the Use of Endorsements and Testimonials in Advertising." Thank you for your trust and support!

0

0

0

76

#shorts #segeln #boot #freigesegelt

0

0

0

327

Hurricane Sandy in Rock Hall, MD My sailing adventures are under way! Please visit our other videos http://www.youtube.com/user/WaterfrontVacations1/videos?flow=grid&view=1

0

0

0

389