close
Welcome aboard to the our video site for sailors. We are being constantly blasted by scammers and pirates, so registration is invite only
contact@sailorsahoy.com with "Invite". No spam, no newsletters. Just a free account
260 Visninger · 15/06/25
321 Visninger · 01/05/25
27,259 Visninger · 20/04/25
1,650 Visninger · 04/04/25
22,216 Visninger · 29/03/25
767 Visninger · 28/03/25
2,432 Visninger · 25/03/25
2,305 Visninger · 18/03/25
2,271 Visninger · 01/03/25
Kossel running Klipper first print with default settings.
0
0
71 Visninger·
12/02/24
I
Sejlbåde
This is my almost 11yr old Kossel, originally created as a „Rostock“ with woodwn base and top plates and steel rods. A lot changed ober the years until now as you might see… Kossel running with a SKR 1.4 board and a RPi 3. No special settings or configuration was done printing this part in PETG. This results in this print being far away from perfect… but for the first print, I think it‘s not too bad
Vis mere
0 Kommentarer
sort Sorter efter
Facebook kommentarer
260 Visninger · 15/06/25
321 Visninger · 01/05/25
27,259 Visninger · 20/04/25
1,650 Visninger · 04/04/25
22,216 Visninger · 29/03/25
767 Visninger · 28/03/25
2,432 Visninger · 25/03/25
2,305 Visninger · 18/03/25
2,271 Visninger · 01/03/25
