BoatSmith Assembles an Eclipse Sailing Catamaran

BoatSmith assembles a Woods Eclipse 33 sailing catamaran set prior to loading it on a truck for delivery. BoatSmith builds complete sailing catamarans or partial sets per client preference. E-mail info@BoatSmithFL.com BoatSmith Woods Eclipse 33 parts featured in this video: Starboard Hull: Hull fabricated to designer specs, gelcoated Bulkhead no. 1 in place with putty; aft side glassed Bulkhead no. 2 cut to fit Bulkhead no. 5 cut to fit; in place with putty Bulkhead no. 6 in place with putty; aft side glassed Floor bulkhead no. 1 in place with putty Floor bulkhead no. 2 in place with putty Floor bulkhead no. 3 in place with putty Floor bulkhead no. 4 in place with putty Floor bulkhead no. 5 in place with putty Floor bulkhead no. 6 in place with putty Sole cut to fit Front bunk cut to fit Aft bunk cut to fit Port Hull Hull fabricated to specs, gelcoated Bulkhead no. 1 in place with putty; aft side glassed Bulkhead no. 2 cut to fit Bulkhead no. 5 cut to fit; in place with putty Bulkhead no. 6 in place with putty; aft side glassed Floor bulkhead no. 1 in place with putty Floor bulkhead no. 2 in place with putty Floor bulkhead no. 3 in place with putty Floor bulkhead no. 4 in place with putty Floor bulkhead no. 5 in place with putty Floor bulkhead no. 6 in place with putty Sole cut to fit Front bunk cut to fit Aft bunk cut to fit Bridal pad assembly port and starboard Skegs port and starboard Belly pan no. 1 cut to fit Cabin sole Belly pan no. 2 Belly pan no. 3 Belly pan no. 4 Bulkhead no. 3 cut to fit Bulkhead no. 4 cut to fit with 2'' on top Front deck and house side Port and starboard hulls fabricated, cut to fit, faired for paint Aft deck and bunk top Port and starboard hulls fabricated, cut to fit, faired for paint Anchor deck with Coosa board inserts 4 anchor locker dividers Coosa board inserts in front deck and house sides for mooring cleats and hardware Coosa board inserts in aft decks and bunk tops for mooring cleats and hardware Bridle pad assembly Coosa board bridle pads, beam knees, beam supports Assembly Directions 1. Using provided measurements mark out hull positions on floor. Position hulls. 4400 cm from centerline to centerline Position diagonals: distance from port stem to starboard stern = distance from starboard stem to port stern 2. Insert bulkhead no. 4. Aft side fits against vertical cut out 3. Slide belly pan no. 1 into place. Pan no. 2 fits under bulkhead no. 4 up against vertical. Leave out pan no. 2 for access into hulls. 4. Insert bulkhead no. 3. It fits into notches cut into belly pan no. 1. 5. Place soles port and starboard. 6. Trim bulkhead no. 2 to desired height and then fit. 7. Insert front bunks. 8. Position bow decks and house sides on hulls. They fit flush and lock into bulkhead no. 4. 9. Place aft bunks. 10. Place aft bunk tops. 11. Cut access holes. 12. Begin fiberglass work. For more information: 561.632.2628 or info@BoatSmithFL.com BoatSmith. We Build Your Dreams. www.BoatSmithFL.com