Building a Wooden Sailboat #12: Chain Plates, Bulkheads, & Interior Paint

In part twelve of this series, I install the chain plates, show how to use "tick sticks" for flagging off and making the fore and aft bulkheads, and clean up the interior of the boat. I radius all the edges in the cockpit and bevel the chine log to shed water. I also sand to a 220 grit finish in prep to paint. Finally I spray on two coats of primer and start rolling on a third coat. Plans & Information: https://snipeusa.com/ https://www.snipe.org/ Supplies: Epoxy - https://amzn.to/2FN7fHp Marine Plywood - https://www.boulterplywood.com/ Sander: https://amzn.to/3bmUG2D Sanding Disks: https://amzn.to/2wkDxYT Vacuum: https://amzn.to/2Uw8ktt Rollers: https://amzn.to/3dinA5Y Scrapers: https://amzn.to/3acOx9i Epoxy Mixer: https://amzn.to/3dohJvN Epoxy Cups: https://amzn.to/394S0p2 Fiberglass Tape: https://amzn.to/2WB2SrW Camera Equipment: Canon SL2 - https://amzn.to/2GPW1ms Tripod - https://amzn.to/2XWVhSd GoPro Hero7 White: https://amzn.to/2ITsqtj