Talking my thru-hike of the Appalachian Trail, life after the trail and what's next for the Barefoot Hiker.

0

0

0

22

The servo is hooked up to the Arduino via pin 9. I've uploaded one of the example sketches you get with Arduino ISP called 'Servo Sweep'. The servo is powered by a 24 volt rough DC supply as you can see in the video. The 20mm steel boss was machined and bored out concentrically to 8.0 mm. A 5.0 mm hole was drilled in the side of the boss and tapped to take an M6 grub screw. The boss was welded into a piece of 1/8 inch steel plate to make the servo arm.

0

0

0

855

Cruising Itinerary from Rocky Point: A 22-foot Vantage Adventure #sailing #boat #shorts

0

0

0

419

Performing sailing pre-passage checks on a sailboat ensures a safe and successful voyage. Ensuring the automatic bilge pump works is one important aspect of these checks. The automatic bilge pump removes any water that enters the boat, whether from rain, waves, or leaks. If the bilge pump is not working, the water could accumulate and cause the boat to become unstable, affecting the boat's performance and putting everyone onboard at risk. By checking the automatic bilge pump before setting sail, you can ensure that it is functioning properly and that any water that enters the boat will be promptly removed. This reduces the risk of damage to the boat and helps prevent potentially dangerous situations from developing. Discover three reasons our automatic bilge went off while sailing so you know what to do if it happens to you. Full article here: https://SailingBritican.com/sailing-pre-passage-checks/ Get the Checklists For Sailors guide here: www.ChecklistsForSailors.com #sailing #checklist #sailinglife

0

0

0

980

Víspera del Pino voz Carlos Domínguez

0

0

0

292

0

0

0

0

92