our fridge in the boat is basically a top-loading, very deep box! I can't even reach the bottom. So how do you organise this? How do you make it functional? How do you prepare your fridge for an ocean crossing? sailing, boatlife, sailing life, preparing to cross an ocean, preparing to sail across an ocean, how do you organise your fridge, the struggles of boatlife, the struggles of sailing, organisation, how to get organised, sailing questions, what do experienced sailors do?

0

0

0

38

Injustice: Gods Among Us Ultimate Edition https://store.playstation.com/#!/es-ar/tid=CUSA00079_00

0

0

0

22

Can You Cook Pasta with Seawater? #boat #sailing #shorts

0

0

0

925

Le #TrimaranSVRLazartigue, construit par l’écurie de course au large de Francois Gabart, est en chantier ! A quelques jours de la mise à l’eau du Trimaran, prévue le 22 juillet, nous venons de réceptionner son mat. Crédit: Guillaume Gatefait #Kresk4Oceans #courseaularge #trimaran #sailing #OffshoreSailing #Sailor #Voile #offshore #sport #Ultim #instasailor #sailstagram #CleanBeauty #BeauteResponsable

0

0

0

1,432

Made out of a bicicle pump! The idea is to use the one way valve that every bicicle pump has on its piston, to improve the performance of the gun, instead of using loose pistons as usually. I know the difference may not be crucial but it's for the sake of well-design. The piston is too heavy but seems to prove the theory. At only 75psi it shoots a 0,2g 6mm plastic bb through a steel (yes, steel. This is Europe) coke can. Filled with water it pierces the can and leaves a mark on the other wall. Air leak detected, soon to be fixed. UPDATE 20150719 Air leak was fixed with teflon tape. Cannon was intended to be tested to 10bar / 145psi. At 8bar / 116psi the back bursted off the main body, propelling it against a wall, with the cannon hitting at a great speed. Result is a bent cannon. Speed doesn't seem to have decreased but precision has been seriously affected. Plans for now are to test the energy at 75psi (like this teaser shows), then cut the cannon to the unbent part (which is about half the lenght), glue the back permanently and test energy again at 75psi to see the relationship between cannon lenglt and muzzle energy. Afterwards, with the back end fully glued, repeat tests at 116psi / 8bar and hopefully get the same energy as full-lenght-cannon @ 75psi. If not, test pressure until total burst, or the desired energy achieved. Advise is greatly appreciated. Thanks for watching! A FewFriendsFace production Likeyright FFF2015 All likes reserved

0

0

0

247

Grand Acar Gulet , Grand Acar Yacht , Bluestar Yachting, Bluestar Yacht Agency www.bluestar-marine.com

0

0

0

213