Cable Industries is an OEM for custom assemblies in Aircraft Cable, Wire Rope, Fiber Rope, Alloy Chain and Webbing. All assemblies are designed and fabricated in our shop in Greenville, WI. For more information, please go to: http://cableind.com or email us at customcable@cableind.com.

0

0

0

282

Quando il mare diventa la tua pista da ballo e gli amici i tuoi compagni di danza! 🌟 Immagina di ballare sotto il cielo stellato, con la brezza marina che accompagna ogni tuo passo e la musica che si fonde con il suono delle onde. 🕺💃 Lasciati andare al ritmo, libera ogni emozione e condividi la gioia di momenti unici con le persone che ami. Ballare in barca a vela non è solo divertimento, è un’esperienza che rafforza legami, crea ricordi e alimenta l’anima. 🚤 Tra sorrisi, passi di danza improvvisati e brindisi al chiaro di luna, queste serate rimarranno impresse come gioielli preziosi nel tesoro dei tuoi ricordi. È la magia di condividere la libertà e la bellezza della vita con gli amici, in mezzo all’immensità del mare. 🌊 👉 Hai mai vissuto la magia di una serata danzante in mare aperto? Condividi il tuo momento più bello o scivola verso l’alto per unirti alla nostra prossima avventura danzante in barca a vela! ☎️+39 347 418 4600 📧francesco.parazzoli@me.com * #sailingboat #sailinginstagram #sailingtrip #sailing #sailboat #yachtinglife #boatinglifestyle #instasailing #sailboating #sailstagram #weekendavela #consiglidiviaggio #sailinglovers #sailingadventures #sailingholidays #ironia #sailinglife #travel #sailingpassion #vacanzeinbarca #meme #funny #comedy #humor #vela #barcaavela #navigare #estate2024 #estateitaliana #nautica

0

0

0

127

0

0

0

0

2,874

Made out of a bicicle pump! The idea is to use the one way valve that every bicicle pump has on its piston, to improve the performance of the gun, instead of using loose pistons as usually. I know the difference may not be crucial but it's for the sake of well-design. The piston is too heavy but seems to prove the theory. At only 75psi it shoots a 0,2g 6mm plastic bb through a steel (yes, steel. This is Europe) coke can. Filled with water it pierces the can and leaves a mark on the other wall. Air leak detected, soon to be fixed. UPDATE 20150719 Air leak was fixed with teflon tape. Cannon was intended to be tested to 10bar / 145psi. At 8bar / 116psi the back bursted off the main body, propelling it against a wall, with the cannon hitting at a great speed. Result is a bent cannon. Speed doesn't seem to have decreased but precision has been seriously affected. Plans for now are to test the energy at 75psi (like this teaser shows), then cut the cannon to the unbent part (which is about half the lenght), glue the back permanently and test energy again at 75psi to see the relationship between cannon lenglt and muzzle energy. Afterwards, with the back end fully glued, repeat tests at 116psi / 8bar and hopefully get the same energy as full-lenght-cannon @ 75psi. If not, test pressure until total burst, or the desired energy achieved. Advise is greatly appreciated. Thanks for watching! A FewFriendsFace production Likeyright FFF2015 All likes reserved

0

0

0

250

0

0

0

0

26