Turpatso yacht management is a company operating on the Mediterranean and Aegean coasts with the aim of offering a quality, safe, hygienic and enjoyable holiday focused on customer satisfaction. It provides this service with the yacht named Destiny, which is within its body. You can see the details on our Destiny page.

0

0

0

322

100% PLEASURE, 100% COMFORT Optimized to make the best use of every space, the Gran Turismo 32 leaves room for imagination allowing a variety of potential uses in all seasons. Light and ventilation are a priority on board. VIEW BOATS FOR SALE https://www.bateswharf.co.uk/used-boats/?makemodel=beneteau

0

0

0

120

0

0

0

0

57

The Tres Hombres crew visited our coffee producer in the mountains of Sierra Nevada de Santa Marta. It's Colombia’s main organic coffee-producing region. You will find plantations of Indigenous groups, rural organizations, and small independent plantations. Lots of speciality coffee will be loaded onto the Tres Hombres and cross the ocean to Amsterdam. After being roasted in a traditional way the coffee will be available in our webshop. Video by http://leohallamdawson.com

0

0

0

1,398

Gabriel Browne will explain the use of tack strap which allows you to add additional profile in the bottom of the sail. Since 2017 in TR race sails tack strap goes around the extension instead of the base as it was before. Check out other #ProTips episodes at www.mauisails.com

0

0

0

1,353

1. Remove the old caulking. We use a special tool from @teakdeckingsystems. 2. If your deck is both screwed and glued, considwe removing the screws. We chose to remove the screws since they only created a possibility for water to enter the construction. 3. Fill out every screw hole with epoxy. During the renovation, we learned it would be a good idea to fill the holes with epoxy as soon as you remove the screws to ensure you seal every single hole. 4. Route between all the teak strips. We routed all the way to the gel coat to have as much wood to work with as possible. We used a fine cutter where the caulking was across the grain. 5. Seam sanding. It helps remove the remaining caulking and gives the teak a fresh bonding surface. 6. Masking the teak strips. We chose to mask the wood to reduce the sanding process later on because we knew the teak wasn’t very thick. 7. Cleaning off with acetone. This helps remove dust and gives the caulking the best conditions to adhere to the wood and cure. 8. Start caulking. We used an air compressor caulking gun. It makes the process easier for large surfaces that need caulking - we used SIS 440 from @teakdeckingsystems. We also used a 3D-printed applicator for the caulk head, which minimizes the amount of caulking used. I could only find it on @hfindustrimarineaps website. 9. “Spoon” caulk further into the seams. We used a flexible putty knife to smoothing the caulking. 10. Pull off the masking. While removing the tape, we used scissors to cut just before the area where it hadn’t been caulked yet. 11. Remove the top of the caulking. We used a sharp stanley knife. We did this to minimize sanding, just as we did with masking. 12. Sanding with grit 80. We used the fine cutter’s sanding head for all the edges and an orbital sander for the larger areas. Side note: Sanding with grit 40. We believe the best way is to sand before routing to even out the wood. Unfortunately, we had many places where the wood was so worn out that it wouldn’t have been possible to follow the old tracks with the router after sanding. #diy #sailing #sailingdiy #teak #teakdeck #sailingdenmark #boatwork #shortoftheday

0

0

0

694