Un charter alle isole Eolie, 26 giugno 2021, partenza da Capo d’ Orlando. A bordo di un Bali 4.6. Skipper Antonio Palermiti

0

0

0

167

Embark on a luxurious journey aboard your own private yacht in paradise. For more information on The Moorings, visit http://www.moorings.com. The Moorings, the world's premier yacht charter company, has delivered unmatched quality, service and attention to detail since 1969. Top of the line sail-it-yourself bareboat yachts, all-inclusive luxury crewed yachts with captain and chef, and innovative power yacht charters are available throughout the world.

0

0

0

1,689,330

Hi All, Welcome to our channel, Here's a link to the full episode , thanks for watch and i hope you watch the full episode. Please remember to leave a like and subscribe to our channel. Link to Episode 33 https://youtu.be/ItiFYkSBtcI If you want to binge watch here is a link to our first season playlist https://www.youtube.com/playlist?list=PLTnjHpfUuECUAA8rwRSxxMvqq9EMx_MR8 We are Andrew and Irene a middle aged (well not sure what age range that encompasses nowadays ) couple pursuing an adventure on the high seas. We sail on the good ship Saracen, a Beneteau Oceanis 473 from 2006. Out journey started in Scotland in early 2023 and our ultimate goal is to sail around the globe …..slowly. We make these videos mostly for family and friends and to create a record of our adventures for ourselves so that we can look back at them later in life, were not in it to make money (way to hard). Thanks for taking an interest and please remember to leave a like, comment and subscribe to our channel, as this helps push the algorithm as we strive to boost our viewers. We also write a blog which can be found here https://www.sailblogs.com/member/saracen/ Link to our noforeignland boat page https://www.noforeignland.com/boat/6490851356180480 Instagram http://www.instagram.com/andrew.campbell386 #SVSaracenstravels #sailinglife #sailing #yachts #sailingaroundtheworld #liveaboardlife #liveaboard #beneteau #oceanis473 #caribbean #yachting #sailingcouple #sailingcaribbean #cruiser #crusinglifestyle #retired #travellingcouple #wanderlust #explore

0

0

0

3

1. Remove the old caulking. We use a special tool from @teakdeckingsystems. 2. If your deck is both screwed and glued, considwe removing the screws. We chose to remove the screws since they only created a possibility for water to enter the construction. 3. Fill out every screw hole with epoxy. During the renovation, we learned it would be a good idea to fill the holes with epoxy as soon as you remove the screws to ensure you seal every single hole. 4. Route between all the teak strips. We routed all the way to the gel coat to have as much wood to work with as possible. We used a fine cutter where the caulking was across the grain. 5. Seam sanding. It helps remove the remaining caulking and gives the teak a fresh bonding surface. 6. Masking the teak strips. We chose to mask the wood to reduce the sanding process later on because we knew the teak wasn’t very thick. 7. Cleaning off with acetone. This helps remove dust and gives the caulking the best conditions to adhere to the wood and cure. 8. Start caulking. We used an air compressor caulking gun. It makes the process easier for large surfaces that need caulking - we used SIS 440 from @teakdeckingsystems. We also used a 3D-printed applicator for the caulk head, which minimizes the amount of caulking used. I could only find it on @hfindustrimarineaps website. 9. “Spoon” caulk further into the seams. We used a flexible putty knife to smoothing the caulking. 10. Pull off the masking. While removing the tape, we used scissors to cut just before the area where it hadn’t been caulked yet. 11. Remove the top of the caulking. We used a sharp stanley knife. We did this to minimize sanding, just as we did with masking. 12. Sanding with grit 80. We used the fine cutter’s sanding head for all the edges and an orbital sander for the larger areas. Side note: Sanding with grit 40. We believe the best way is to sand before routing to even out the wood. Unfortunately, we had many places where the wood was so worn out that it wouldn’t have been possible to follow the old tracks with the router after sanding. #diy #sailing #sailingdiy #teak #teakdeck #sailingdenmark #boatwork #shortoftheday

0

0

0

694

0

0

0

0

93

0

0

0

0

107