0

0

0

0

51

Join us for an exciting journey as we tackle boat repairs and embrace a new chapter in life! From wrestling with stubborn wiring under a desk to celebrating a fresh start on the open water, this video captures the highs and lows of our adventure. Watch now to see how we overcome challenges and make our dreams a reality! #BoatLife #NewBeginnings #DIY #BoatRepair #OceanLife #AdventureTime #LifeGoals #MarinaLife #ChallengesAndTriumphs #SailingVlog

0

0

0

35

The idea behind it is that it hangs onto thin veneers that may otherwise flutter against the tablesaw blade as it reaches the end of the cut. There are other methods for cutting thin veneers which you can explore on YouTube. I find this helpful because it hangs onto the finished veneer as I tend to the billet it just came off. It is also helpful in that it is a one-fence-setting system, unlike cutting veneers off the outboard face of the blade. Of course a fresh push stick is a good idea as is a zero clearance throat plate in your saw. For most standard table saws, that is a simple project in itself. I have a pattern that allows me to make new ones easily. Subject for another video. The extended backboard allows me to fasten this jig to my Jim Tolpin style fence extension. Detail of that can be found in Jim Tolpin’s Tablesaw Magic book. A worthwhile read in its own right. You could eliminate the backboard and recess the end caps allowing f-body clamps to reach in and hold it to any tablesaw fence. I’ll leave other solutions to your own innovation. I use this jig with a Fein shop vac which has a volume control. I was surprised how low I had to turn it down to prevent the stock from locking itself firmly onto the fence, preventing me from feeding it through the blade. You may have to increase the number of saw kerfs through the front of the fence until you find the sweet spot for your vacuum. I would do it one kerf at a time. Note that the kerfs pass all the way through the fence face such that they are exposed on the ends. That is to allow the air to pass behind the stock. I hope this is useful to some of you. Happy wood butchering folks.My website: https://www.nomadboatbuilding.com Instagram: https://www.instagram.com/nomadboatbuilding/ It's not about the money but living isn't free... Products featured in this video: Buy some merch: https://www.nomadboatbuilding.com/shop/ Support these videos with monthly or annual pledges at Patreon: https://www.patreon.com/nomadboatbuilding Or make a one time donation: https://www.paypal.com/paypalme/nomadboatbuilding

0

0

0

1,145

I hope that all of you can make it to the Strictly Sail Pacific Boat Show taking place April 9-12th 2015 to see the latest Jeanneau Yachts on display. We will be featuring the Jeanneau 349so, 379so, 409so, 41 Deck Salon, 469so and the Jeanneau 53 Yacht and Jeanneau 57 Yacht. A great line up and if you are interested in buying or selling a yacht please contact me at any time day or night at ivtyachtsales@gmail.com I look forward to hearing from you. Best, Ian Van Tuyl

0

0

0

306

0

0

0

0

295