#vidaabordo #veleirocabana #veleiro

0

0

0

1,621

The third passage race of West Highland Yachting week 2022 from Tobermory to Oban once again provided some close racing at the first turning mark. The J109 BlueJay just got across the bow of the second J109 Going to Red. The they were closely followed by the 3rd J109 Salamander who was forced to go wide as the fast charging Sigma 400 Sunrise with no mark room decided to ignore the rules and gybe in side rather than luffing to keep clear. It was a little disappointing that Sunrise failed to do any penalty turns after breaking the rules, karma came to the rescue of the boats who followed the rules as Sunrise's kit wrapped around the forestay which allowed Salamander to luff up under them retaking 3rd place on the long run to Oban. BlueJay showed a clean pair feels leading from start to finish just beating Salamander to win the race, GTR learnt that polars are king when one design racing and learnt the hard way that low and slow is not the way to go when racing a J109 down wind. There was lots of tight racing across the whole week which made for a great regatta in the Scottish Highlands. The team at Bottom Up Boat hope you are enjoying the action from WHYW 2023.

0

0

0

4,433

0

0

0

0

1,384

Finding the best place to anchor when you have the whole bay to yourselves. Sometimes it's more difficult than you imagine to find the best place to anchor when you have the whole bay to yourselves...might as well have a proper, good look round before choosing! This is Phang Nga bay in Thailand, next to James Bond Island. ****************************** Be one of the good guys: https://www.patreon.com/followtheboat Be the first to know: http://eepurl.com/B9Ykn Subscribe to our youtube channel: https://www.youtube.com/subscription_center?add_user=spannerheadz Blog: http://www.followtheboat.com Facebook: https://www.facebook.com/followtheboat Instagram: http://www.instagram.com/followtheboat ****************************** Music by Kevin MacLeod ( 'Baltic Levity') http://www.incompetech.com

0

0

0

2,881

This angle guide is designed to set the correct angle between the tool rest and the platen for sharpening chisels. The 25° primary level is measured with a corresponding 155° obtuse angle. The 30° micro bevel is measured with a 150° obtuse angle. T #woodworking #shipwright #diy #boatbuilding his guide references the actual measured an angle between surfaces, making set up, simple and precise.

0

0

0

1,069

0

0

0

0

119