If you are looking for exceptional cruising comfort with maximum cabin & cockpit space, look no further than the Hunter brand. These boats are so popular and highly sought after as the design is always incredibly spacious for the LOA. Finished in beautiful wood work, the interior is bright and airy thanks to 9 opening hatches and 7 opening ports to keep the cabin space well ventilated. “Ellipsis” has a 2 cabin layout with the master aft cabin extending across the full beam of the boat. The forward cabin has its own vanity and sink and the large enclosed head offers a separate shower stall. The galley is well laid out with a large fridge, separate freezer, 3 burner stove with oven and microwave. Topsides the deck stepped fractional rig with a furling Main and Genoa makes sailing a breeze whether single handed or fully crewed. With a new bimini and new GPS matched with Raymarine electronics, this vessel comes complete with assumable moorage and a Zodiac dinghy with Honda outboard to complete the package. Currently off-site and available to view by appointment only. Please contact our Vancouver Island Sales Office at 250-656-5832 to schedule a showing.

0

0

0

241

Partenza della regata del Conero 2016 dalla linea

0

0

0

78

Avfärd från Karlskrona med nedpackningsceremoni

0

0

0

73

0

0

0

0

4,826

The idea behind it is that it hangs onto thin veneers that may otherwise flutter against the tablesaw blade as it reaches the end of the cut. There are other methods for cutting thin veneers which you can explore on YouTube. I find this helpful because it hangs onto the finished veneer as I tend to the billet it just came off. It is also helpful in that it is a one-fence-setting system, unlike cutting veneers off the outboard face of the blade. Of course a fresh push stick is a good idea as is a zero clearance throat plate in your saw. For most standard table saws, that is a simple project in itself. I have a pattern that allows me to make new ones easily. Subject for another video. The extended backboard allows me to fasten this jig to my Jim Tolpin style fence extension. Detail of that can be found in Jim Tolpin’s Tablesaw Magic book. A worthwhile read in its own right. You could eliminate the backboard and recess the end caps allowing f-body clamps to reach in and hold it to any tablesaw fence. I’ll leave other solutions to your own innovation. I use this jig with a Fein shop vac which has a volume control. I was surprised how low I had to turn it down to prevent the stock from locking itself firmly onto the fence, preventing me from feeding it through the blade. You may have to increase the number of saw kerfs through the front of the fence until you find the sweet spot for your vacuum. I would do it one kerf at a time. Note that the kerfs pass all the way through the fence face such that they are exposed on the ends. That is to allow the air to pass behind the stock. I hope this is useful to some of you. Happy wood butchering folks.My website: https://www.nomadboatbuilding.com Instagram: https://www.instagram.com/nomadboatbuilding/ It's not about the money but living isn't free... Products featured in this video: Buy some merch: https://www.nomadboatbuilding.com/shop/ Support these videos with monthly or annual pledges at Patreon: https://www.patreon.com/nomadboatbuilding Or make a one time donation: https://www.paypal.com/paypalme/nomadboatbuilding

0

0

0

1,145