BIG ANNOUNCEMENT!!!!!!!!! We are appearing at the Annapolis SailBoat Show from the 10th - 14th October 2024. We will be part of the Cruisers Creating Content Stand (YouTubers) We will be there everyday throughout the Sailboat show and there is lots to see and do and events to get involved in, so please come along and pay us a visit at the Booth! We can’t wait to meet YOU!!! https://annapolisboatshow.com AND… we are doing a very special Patron ONLY meet up, so if you are a patron or want to be one follow the link to Patreon and find all the information regarding coming to spend some time with us and have a patron ONLY Pickle family celebration! http://www.patreon.com/sailingpicklefamily WOOOHOOO

0

0

0

2,110

With its deep V-hull and Alaskan bulkhead, the HewesCraft SeaRunner 220 is the perfect commuter/fishing boat in all weather conditions. It is powered by a 150 hp Yamaha engine with 836 hours, and also has a F9.9 yamaha high thrust kicker. The fully enclosed cabin is comfortable with two spring loaded seats and two bench seats. The bow area with an in-floor fish box is easily accessed through a sturdy walk-thru door. Other features include a Garmin GPS and trim tabs. Call for an appointment to view.

0

0

0

8,713

Have the chance to discover dolphins & whales in Fuerteventura. Come to the port of Morro Jable and join us in a sailing boat trip😍🐳🐬 👉 www.magicandsailing.com 📱+34 630 975 023 #canarias #dolphin #nature #holidays #tour

0

0

0

3,108

0

0

0

0

485

Made out of a bicicle pump! The idea is to use the one way valve that every bicicle pump has on its piston, to improve the performance of the gun, instead of using loose pistons as usually. I know the difference may not be crucial but it's for the sake of well-design. The piston is too heavy but seems to prove the theory. At only 75psi it shoots a 0,2g 6mm plastic bb through a steel (yes, steel. This is Europe) coke can. Filled with water it pierces the can and leaves a mark on the other wall. Air leak detected, soon to be fixed. UPDATE 20150719 Air leak was fixed with teflon tape. Cannon was intended to be tested to 10bar / 145psi. At 8bar / 116psi the back bursted off the main body, propelling it against a wall, with the cannon hitting at a great speed. Result is a bent cannon. Speed doesn't seem to have decreased but precision has been seriously affected. Plans for now are to test the energy at 75psi (like this teaser shows), then cut the cannon to the unbent part (which is about half the lenght), glue the back permanently and test energy again at 75psi to see the relationship between cannon lenglt and muzzle energy. Afterwards, with the back end fully glued, repeat tests at 116psi / 8bar and hopefully get the same energy as full-lenght-cannon @ 75psi. If not, test pressure until total burst, or the desired energy achieved. Advise is greatly appreciated. Thanks for watching! A FewFriendsFace production Likeyright FFF2015 All likes reserved

0

0

0

247