Welcome aboard to the our video site for sailors. We are being constantly blasted by scammers and pirates, so registration is invite only
contact@sailorsahoy.com with "Invite". No spam, no newsletters. Just a free account
Celana pendek Membuat
0
0
0
0
62
https://www.scanboat.com/en/boat-market/boats/sailingboat-beneteau-381-performance-17522214 Sailingboat - Både sælges, Beneteau 38.1 Performance, 2022 SEK 3.140.000 Scanboat It’s a brand new boat (built 2022) launched first time and in use first time 2025. Nice grey sails from Elvström Sleipner SEP80 variable bowthruster with hold function. Sprayhood and Bimini and complete tent from 2025. Ebersprecher D6 from 2025. New lazy bag modified better than original. Performance model with 1,2 m higher mast than original 38.1 New rocna anchor and chain. Yanmar 40 hp with sail drive 3 blade flexi fold. Walnut interior with bright floorboards .
0
0
0
4,411
From dockside meetings in Phuket to insightful conversations around design, customization and eco-innovation, the show highlighted Southeast Asia’s growing interest in luxury multihulls built for long-range cruising and responsible yachting.Thank you to everyone who joined us and shared our vision for what’s next at sea.Next stop: Miami International Boat Show | 11–15 February#SunreefYachts #ThailandBoatFestival #MiamiInternationalBoatShow #LuxuryCatamarans #MultihullLife
0
0
0
403
Met een goed regenjasje van HH over je midlayer jacket aan en dan speciale industriële rubber werkhandschoenen ben je warm en droog. En met deze handschoenen kan je ook je B&G plotter touchscreen bedienen. #BandG #regen #hellyhansen #Zeus3 #rotweer #hanseyachts #xclusivesailing
0
0
0
126
0
0
0
118
The servo is hooked up to the Arduino via pin 9. I've uploaded one of the example sketches you get with Arduino ISP called 'Servo Sweep'. The servo is powered by a 24 volt rough DC supply as you can see in the video. The 20mm steel boss was machined and bored out concentrically to 8.0 mm. A 5.0 mm hole was drilled in the side of the boss and tapped to take an M6 grub screw. The boss was welded into a piece of 1/8 inch steel plate to make the servo arm.
0
0
0
855
