close

Welcome aboard to the our video site for sailors. We are being constantly blasted by scammers and pirates, so registration is  invite only


contact@sailorsahoy.com with "Invite". No spam, no newsletters. Just a free account

短裤 创造

0

voiliersargasea6812

0

0

265

Formula 34 PC https://www.scanboat.com/en/17296884

scanboat24

0

0

322

0

velhojacksn

0

0

615

Top Veggies for Sailing Adventures! #boat #sailing #shorts

kiltmansailing

0

0

923

Would you change seacock valve 65cm below the water line whilst afloat?! It might not be as scary as you think. This valve body seized up (despite only being 3-4 years old) so I unscrewed it, popped in a wooden bung, bought a new one and screwed it on. The trick is to be prepared. I had all my wooden bungs on hand, covered any electrical equipment and was ready for the worst case scenario. Fortunately, because it was a fairly new fitting, it came undone relatively easily and the job was pretty straight forward 😊💦 And what’s the worst case scenario I was prepared for? The worst case scenario is the thru hull fitting itself breaking off when I attempt to unscrew the valve. What would I do about it? Just tap in one of my many wooden bungs and then arrange to get the boat lifted out! That scenario was quite unlikely but it helps to think through what could happen. What also helped me is that, from previous experimentation on another boat, we have pumps that I know could easily outrun the water coming in through that hole. An uncontrolled inflow through that fitting wouldn’t be good as it would spray seawater everywhere but it’s good to know that the pumps could cope. It’s always counter intuitive and panic inducing to see water flooding in to the boat and I know many people don’t like to pull out their paddle wheel log transducers for that very reason however staying calm and knowing that it would actually take quite a long time to sink through a 3/4” hole means it may not be as bad as you think. Always worth thinking what else could help. Whilst away, shopping for parts, I left Kate armed with cushions as well as wooden bungs as a cushion pushed hard over a hole will slow the flow enough that most bilge pumps would cope. Despite my previous experiments I was even surprised how little water we took on but the point is that, with a little thought and prep, changing a valve or pulling that paddle wheel so it doesn’t foul up needn’t be that stressful or require an expensive lift out. Luckily for me everything went super smoothly this time so no need for backup plans! It does get the heart pumping a bit when you haven’t done it for a while though! 😊💦 #followintrepidbear #sailinglife #sailing #sailor #liveaboard #sailboat #boatlife

followintrepidbear

0

0

662

- Clicca Mostra Altro per leggere la descrizione completa ed i link contenuti nel video. Vieni a trovarci su http://www.giornaledellavela.com - Siamo anche su Facebook https://www.facebook.com/giornaledellavela - E su Instagram https://www.instagram.com/giornaledellavela - Il primo Salone della nautica - Boat Show digitale https://www.milanoyachtingweek.com/ -Descrizione Video Andrea Mura: "Stiamo a casa con la famiglia e approfittiamone per progettare, innovare, meditare" Clicca qui per scoprire le formule di abbonamento al Giornale della Vela https://subscribe.giornaledellavela.com/ - DISCLAIMER Il presente video è stato creato a scopo divulgativo. Il Canale Giornale della Vela e gli autori dei video non si assumono alcuna responsabilità circa l'utilizzo del contenuto di questo video. Dal 1974 Panama Editore si occupa del mondo della nautica e del turismo attraverso pubblicazioni cartacee e digitali; siti internet di informazione e servizio; eventi, attività di e-commerce e didattiche. Il Giornale della Vela, la rivista leader di vela in Italia ed il sito www.giornaledellavela.com sono a tua disposizione per trovare informazioni e contenuti aggiornati quotidianamente su crociere, regate, cantieristica, novità del mercato, prove barca. Music Credit - Youtube Free Audio Library

giornaledellavela

0

0

441