CAVU 4, a Hinckley Sport Boat 40x with the highly desirable twin Mercury 600 hp engine package, represents an opportunity to own a thoughtfully customized Hinckley Sport Boat 40x immediately. She has been maintained exclusively by Hinckley Yacht Services in our YachtCare program. CAVU 4 was built to have a more “Hinckley” look than sisterships, featuring a full exterior teak package varnished to perfection, natural teak decking in the cockpit and pilothouse, and a teak transom. If you are considering a very lightly used Hinckley Sport Boat 40x, with less than 100 hours for your cruising needs, take a close look at CAVU 4 and call for an appointment to see her today! Listing Link: https://hinckleybrokerage.com/yachts-for-sale/hinckley-sport-boat-40-x-2022-4249130/

0

0

0

1,458

Check out the link below for full instructions on how to tie the Highwayman's Hitch. https://youtu.be/USjyE1nTV9Q The Highwayman’s hitch is a quick-release draw hitch used for temporarily securing a load that will need to be released easily and cleanly. The hitch can be untied with a tug of the working end, even when under tension. The highwayman's hitch can be tied in the middle of a rope, and so the working end does not need to be passed around the anchor when tying or releasing. The knot is three bights that each successively lock the previous one: - The first one, in the middle of the rope, wraps around the pole, - The second one (called the toggle bight) is a bight of the standing part locking the first one so the pole is held tight, and - The third one (called the slip-tuck) is a bight of the working part (slack end) locking the second bight. The locking actions are achieved by reaching through each bight to pull the next one through. The knot has to be finished by pulling the standing part tight to ensure that it holds. Until the knot is tightened and properly dressed, the highwayman's hitch has little holding power. The highwayman's hitch is susceptible to capsizing when the pole is substantially larger than the rope diameter. The failure occurs because the second bight sees the force of the standing part, but is held in place by the working part, which has no tension. When capsizing, tension on the standing part pulls the second bight through the first bight. This drags the slip-tuck through, and will release the hitch if the third bight isn't long enough. The team at bottom up boats hope you enjoyed our latest video demonstration where we teach you how to tie the highwayman's hitch.

0

0

0

71,540

Hobie Fishing hits up Lake San Vicente in this sweet clip that has us wishing for the weekend.

0

0

0

1,156