close

Welcome aboard to the our video site for sailors. We are being constantly blasted by scammers and pirates, so registration is  invite only


contact@sailorsahoy.com with "Invite". No spam, no newsletters. Just a free account

Korte broek Opprett

In this video we compare waterproofness and flotation of the ICOM M94D and iPhone (8 and later). Disclaimer: - This content is offered solely for your education and entertainment. - There are no warranties, expressed or implicit, about any content or its fitness for a particular purpose. - There are risks of injury, death, drunkenness, and financial hardship involved in sailing. - The skipper is always responsible for the safety of their vessel and crew. - Sailing Tips is not responsible or liable in any way for anything that happens on or anywhere near your boat or any boat that we are not in command of. #shorts #icomm94d #handheld #vhf #iphone #waterproof #float #sailing #sailingtips

Sailingtipsca

0

0

6,204

Made out of a bicicle pump! The idea is to use the one way valve that every bicicle pump has on its piston, to improve the performance of the gun, instead of using loose pistons as usually. I know the difference may not be crucial but it's for the sake of well-design. The piston is too heavy but seems to prove the theory. At only 75psi it shoots a 0,2g 6mm plastic bb through a steel (yes, steel. This is Europe) coke can. Filled with water it pierces the can and leaves a mark on the other wall. Air leak detected, soon to be fixed. UPDATE 20150719 Air leak was fixed with teflon tape. Cannon was intended to be tested to 10bar / 145psi. At 8bar / 116psi the back bursted off the main body, propelling it against a wall, with the cannon hitting at a great speed. Result is a bent cannon. Speed doesn't seem to have decreased but precision has been seriously affected. Plans for now are to test the energy at 75psi (like this teaser shows), then cut the cannon to the unbent part (which is about half the lenght), glue the back permanently and test energy again at 75psi to see the relationship between cannon lenglt and muzzle energy. Afterwards, with the back end fully glued, repeat tests at 116psi / 8bar and hopefully get the same energy as full-lenght-cannon @ 75psi. If not, test pressure until total burst, or the desired energy achieved. Advise is greatly appreciated. Thanks for watching! A FewFriendsFace production Likeyright FFF2015 All likes reserved

donotpushhere

0

0

247

Galveston Bay 8/13/23 #sailing #racing #texas #wind #water #fun

Tnick340

0

0

160

Discover a world of thrilling experiences and breathtaking destinations as you set sail on our adventure-filled charters. For more information on The Moorings, visit http://www.moorings.com

themooringscharters

0

0

538

tiki boat adventures key west sandbar trips

tikiboatadventures

0

0

23

Peter Bruun Grinde https://www.scanboat.com/en/17381457

scanboat24

0

0

376