0

0

0

0

328

Stari Grad is a picturesque little town in the north of the island of Hvar and is the second largest town there, after Hvar Town. Stari Grad translates to Old Town, and this beautiful spot is actually one of the oldest towns in Croatia. If you’re looking for a quaint little place away from the hustle and bustle of everyday life, then Stari Grad will fit your bill perfectly. Discover the top things to do in Stari Grad: 1. Visit the Church of St. Stephen and take in the impressive architecture 2. Visit Trvdaj Castle and discover the fish pond, gallery and beautiful gardens 3. Indulge in a wine and local produce tasting at the UNESCO protected Stari Grad Plain For a comprehensive guide on this to do, places to visit and where to eat and drink in Stari Grad, you won't want to miss our Stari Grad Destination Guide: https://www.sail-croatia.com/set-sail/destination/stari-grad

0

0

0

3,324

1. Remove the old caulking. We use a special tool from @teakdeckingsystems. 2. If your deck is both screwed and glued, considwe removing the screws. We chose to remove the screws since they only created a possibility for water to enter the construction. 3. Fill out every screw hole with epoxy. During the renovation, we learned it would be a good idea to fill the holes with epoxy as soon as you remove the screws to ensure you seal every single hole. 4. Route between all the teak strips. We routed all the way to the gel coat to have as much wood to work with as possible. We used a fine cutter where the caulking was across the grain. 5. Seam sanding. It helps remove the remaining caulking and gives the teak a fresh bonding surface. 6. Masking the teak strips. We chose to mask the wood to reduce the sanding process later on because we knew the teak wasn’t very thick. 7. Cleaning off with acetone. This helps remove dust and gives the caulking the best conditions to adhere to the wood and cure. 8. Start caulking. We used an air compressor caulking gun. It makes the process easier for large surfaces that need caulking - we used SIS 440 from @teakdeckingsystems. We also used a 3D-printed applicator for the caulk head, which minimizes the amount of caulking used. I could only find it on @hfindustrimarineaps website. 9. “Spoon” caulk further into the seams. We used a flexible putty knife to smoothing the caulking. 10. Pull off the masking. While removing the tape, we used scissors to cut just before the area where it hadn’t been caulked yet. 11. Remove the top of the caulking. We used a sharp stanley knife. We did this to minimize sanding, just as we did with masking. 12. Sanding with grit 80. We used the fine cutter’s sanding head for all the edges and an orbital sander for the larger areas. Side note: Sanding with grit 40. We believe the best way is to sand before routing to even out the wood. Unfortunately, we had many places where the wood was so worn out that it wouldn’t have been possible to follow the old tracks with the router after sanding. #diy #sailing #sailingdiy #teak #teakdeck #sailingdenmark #boatwork #shortoftheday

0

0

0

694

Birchwood 33 Fly https://www.scanboat.com/en/17365255

0

0

0

282

The all-new Hallberg-Rassy 412 for the 2012 season. Option of twin aft cabins. One or two heads. Lots of natural light. Large aft cockpit. Clean deck layout and easy to handle sailplan.

0

0

0

13,575

Lälut hindrar rundning i en RS Quest, klassiskt misstag, håll båten plant! Grundkursens 4:e dag.

0

0

0

272