Welcome to Sailboat Stuff! ⛵️ Thank you for taking time to watch this video 😃. Hope you will👍like, share and subscribe. ☆Channel support option☆ patreon.com/sailboatstuff https://www.buymeacoffee.com/sailboatstuff https://www.amazon.com/hz/wishlist/ls/2IHZA9ILQSRGR?ref_=wl_share ☆Contact me☆ sailboatstuff1@gmail.com

0

0

0

73

Terminal manual para obenques, estays y backstays. Cuando no podemos pasar un estay, obenque o backstay porque el terminal es demasiado grueso, tenemos la solución de los terminales tipo Norseman. Son terminales que se montan a mano, in situ. Muchas veces, cuando queremos montar un estay dentro de un enrollador viejo, este último no se puede desmontar, ya que sus componentes están gripados, unidos entre sí por la diferencia de metales y el paso del tiempo. Si quieres que te haga un trabajo, que revise tu barco o que te lo inspeccione para una compraventa, contacta conmigo en 607907454 o txemacapitan@gmail.com

0

0

0

878

0

0

0

0

58

This is a clip from our Husqvarna 308 Automower. The robot mower has sensor wire in the ground that defines his workarea. It has an alarm when taken off the ground. It can be programmed to define the mowing hours. There is no logic in the path it takes, just random straight lines.

0

0

0

288

Made out of a bicicle pump! The idea is to use the one way valve that every bicicle pump has on its piston, to improve the performance of the gun, instead of using loose pistons as usually. I know the difference may not be crucial but it's for the sake of well-design. The piston is too heavy but seems to prove the theory. At only 75psi it shoots a 0,2g 6mm plastic bb through a steel (yes, steel. This is Europe) coke can. Filled with water it pierces the can and leaves a mark on the other wall. Air leak detected, soon to be fixed. UPDATE 20150719 Air leak was fixed with teflon tape. Cannon was intended to be tested to 10bar / 145psi. At 8bar / 116psi the back bursted off the main body, propelling it against a wall, with the cannon hitting at a great speed. Result is a bent cannon. Speed doesn't seem to have decreased but precision has been seriously affected. Plans for now are to test the energy at 75psi (like this teaser shows), then cut the cannon to the unbent part (which is about half the lenght), glue the back permanently and test energy again at 75psi to see the relationship between cannon lenglt and muzzle energy. Afterwards, with the back end fully glued, repeat tests at 116psi / 8bar and hopefully get the same energy as full-lenght-cannon @ 75psi. If not, test pressure until total burst, or the desired energy achieved. Advise is greatly appreciated. Thanks for watching! A FewFriendsFace production Likeyright FFF2015 All likes reserved

0

0

0

247

Fog was variable, my AIS doesn't always display the barges so I was on high alert visually. StarSloop on the Loop Short # 44 #aglca​ #Starsloop​ #greatloop​ #macgregor​ #MTLSA​ #boatdog​ #Galactica #dog #waterdog

0

0

0

123