King Propulsion will be attending the Annapolis Spring Sailboat Show. On display will be the Varifold folding sailboat propeller, Autoprop feathering propeller and SigmaDrive shaft coupling.

0

0

0

74

Who needs farm to table when you have sea to grill?! Captain Alex grills up fresh Anegada, BVI lobster during the all-inclusive luxury crewed catamaran charter offered by @virgincharteryachts aboard the new Samana 59 'Perfect Landing' Perfect Landing is a new Fountaine Pajot Samana 59 catamaran. Perfect Landing can accommodate 10 guests in 5 Queeen cabins, all with ensuite heads. There is a full-time crew of three; captain, chef and stewardess, who will attended to your every need. The chef will plan all the meals around your personal tastes and preferences and the captain will plan a customized itinerary around the best spots in the BVI. A charter vacation often includes many of the most popular BVI spots including; The Baths Virgin Gorda, Soggy Dollar Bar on Jost Van Dyke, Foxy's, the Willy T on Norman Island, Cooper Island Beach Club, The Bitter End Yacht Club and the beautiful island of Anegada. #bvi #powercat #britishvirginislands #tortola #traveltheworld #explore #beautifuldestinations #powercatamaran #yachting #boatlife #yachtworld #Travel #adventure #moorings #marinemax

0

0

0

81

AMEL 55 HARD TOP 2013 INTRODUCED BY FUTURA YACHT WWW.FUTURAYACHT.COM

0

0

0

3,001

The idea behind it is that it hangs onto thin veneers that may otherwise flutter against the tablesaw blade as it reaches the end of the cut. There are other methods for cutting thin veneers which you can explore on YouTube. I find this helpful because it hangs onto the finished veneer as I tend to the billet it just came off. It is also helpful in that it is a one-fence-setting system, unlike cutting veneers off the outboard face of the blade. Of course a fresh push stick is a good idea as is a zero clearance throat plate in your saw. For most standard table saws, that is a simple project in itself. I have a pattern that allows me to make new ones easily. Subject for another video. The extended backboard allows me to fasten this jig to my Jim Tolpin style fence extension. Detail of that can be found in Jim Tolpin’s Tablesaw Magic book. A worthwhile read in its own right. You could eliminate the backboard and recess the end caps allowing f-body clamps to reach in and hold it to any tablesaw fence. I’ll leave other solutions to your own innovation. I use this jig with a Fein shop vac which has a volume control. I was surprised how low I had to turn it down to prevent the stock from locking itself firmly onto the fence, preventing me from feeding it through the blade. You may have to increase the number of saw kerfs through the front of the fence until you find the sweet spot for your vacuum. I would do it one kerf at a time. Note that the kerfs pass all the way through the fence face such that they are exposed on the ends. That is to allow the air to pass behind the stock. I hope this is useful to some of you. Happy wood butchering folks.My website: https://www.nomadboatbuilding.com Instagram: https://www.instagram.com/nomadboatbuilding/ It's not about the money but living isn't free... Products featured in this video: Buy some merch: https://www.nomadboatbuilding.com/shop/ Support these videos with monthly or annual pledges at Patreon: https://www.patreon.com/nomadboatbuilding Or make a one time donation: https://www.paypal.com/paypalme/nomadboatbuilding

0

0

0

1,145

re-upload l l Zach Kelley. Braden Grandinetti Jabari Furry

0

0

0

389

0

0

0

0

31