Những video mới nhất
Testing the towing capabilities of the electric water-jet surfboard. Running around 15kw electrical power from battery for this test.
Location: Botany Bay/Cronulla Beach, Sydney, Australia. Riding a 1998 SeaDoo XPL, powered by the Rotax 950cc 2 stroke, 2 cylinder engine. The engine in my ski is running SBT pistons at 1.0mm overbore and SBT carb parts.
Quickest JetBoard yet? Electric board with super high thrust water jet and JetSki level acceleration
A project I have been designing and improving for the last few months! Inspiration for performance requirements was taken from SeaDoo's 2 stroke Jet Ski's. An electrical power of 18000w or 24hp is drawn from the 4kWh/25kg of batteries. An estimated 13000w, or 17.5hp (horsepower) is mechanically delivered to the Water Jet Pump via the brushless electric motor that weighs in at under 5kg. The Jet Pump unit in the board is built from a combination of machined and laser cut aluminium. As well as PETG 3d printed components that are sanded smooth for better efficiency. The intake duct for the jet being the largest 3d printed component. All printed components were printed on a Creality CR-10 3d printer.
Custom designed electric water-jet pump on a fibreglass laminated foam core board.
Some VESC data in sync with 16S full speed run, good thing there wasn't more damage as a result of the crash.
Top speed run on the efoil with 16S! The VESC motor current limit was set at 255 amps. Prop was turning at roughly 4800rpm. - 16S11P samsung 25r 18650 battery pack, bypassed BMS so is only used for charging. - SSS56104 500KV motor - Neugart PLE040 5:1 gearbox - VESC 75/300ESC - Slingshot Infinity 76 surf foil - Custom board - Maytech remote - custom aluminium prop, no duct
airtime on the 1993 xp
Some efoil footage from late 2019 ?
Pushing the 26 year old SeaDoo to its limit!!
Propulsion system statistics of the DIY efoil. At full throttle the motor is doing 20,000 rpm, that's 333 turns per second! Motor rpm is reduced with a planetary gearbox down to 4000rpm for the propeller, while the torque output is around 9.5nm at full speed. The prop torque can go up to 11.25n.m while rpm can go up to 5000 (25000 rpm, 2.25nm at motor) more speed is possible with a higher voltage battery!
0
Getting some airtime
This vid shows the top speed: https://www.youtube.com/watch?v=gzhQLi79nSc
A palm sized electric motor can handle enough power to move a 105kg mass at more than 40kmh, on water! See this vid for some more on the eFoil: https://www.youtube.com/watch?v=BadBNv5qcL4
0
0
0
Improving and testing the prototype. *V2.0 will have a higher top speed: over 40Kph* *Current top speed is 33Kph - not fast enough* Music: |Scrape the sky - can't stop won't stop|
Testing the eFoil prototype! Get around it!
Testing DIY direct drive foil in the lake.
