شلوار کوتاه ایجاد کردن
Kayaking and sailing in Baja!
0
0
0
868
0
0
0
0
9,335
0
0
0
0
124
Since May 10th, the Race for Water team and scientists from GIS Posidonie have been on a mission to locate historical markers installed in the 1980s to monitor the evolution of Posidonia oceanica in the PACA region of southern France. Before making a stop in Nice for the United Nations Ocean Conference, they explored five sites between Marseille and Saint-Aygulf. In an exclusive report, Bruno Belloni and Patrick Astruch, scientists from GIS Posidonie, share their first insights : from key findings to their biggest challenge and greatest satisfaction, they tell it all ! -- Depuis le 10 mai, l'équipe de Race for Water et les scientifiques du GIS Posidonie sont partis à la recherche de balisages historiques installés dans les années 80 pour suivre l'évolution de la Posidonie en Région PACA. Avant de faire escale à Nice pour la Conférence des Nations Unies pour l'Océan, ils ont pu explorer 5 sites entre #Marseille et #Saint Aygulf. En exclusivité, Bruno Belloni et Patrick Astruch, scientifiques du GIS Posidonie, livrent les premiers retours : entre le bilan, leur plus grande difficulté et leur plus grande satisfaction, ils vous racontent tout !
0
0
0
7
¿Adivina de Quién es la Frase? 409 #citas #frases #adivinadequieneslafrase
0
0
0
2,513
The idea behind it is that it hangs onto thin veneers that may otherwise flutter against the tablesaw blade as it reaches the end of the cut. There are other methods for cutting thin veneers which you can explore on YouTube. I find this helpful because it hangs onto the finished veneer as I tend to the billet it just came off. It is also helpful in that it is a one-fence-setting system, unlike cutting veneers off the outboard face of the blade. Of course a fresh push stick is a good idea as is a zero clearance throat plate in your saw. For most standard table saws, that is a simple project in itself. I have a pattern that allows me to make new ones easily. Subject for another video. The extended backboard allows me to fasten this jig to my Jim Tolpin style fence extension. Detail of that can be found in Jim Tolpin's Tablesaw Magic book. A worthwhile read in its own right. You could eliminate the backboard and recess the end caps allowing f-body clamps to reach in and hold it to any tablesaw fence. I'll leave other solutions to your own innovation. I use this jig with a Fein shop vac which has a volume control. I was surprised how low I had to turn it down to prevent the stock from locking itself firmly onto the fence, preventing me from feeding it through the blade. You may have to increase the number of saw kerfs through the front of the fence until you find the sweet spot for your vacuum. I would do it one kerf at a time. Note that the kerfs pass all the way through the fence face such that they are exposed on the ends. That is to allow the air to pass behind the stock. I hope this is useful to some of you. Happy wood butchering folks.My website: https://www.nomadboatbuilding.com Instagram: https://www.instagram.com/nomadboatbuilding/ It's not about the money but living isn't free... Products featured in this video: Buy some merch: https://www.nomadboatbuilding.com/shop/ Support these videos with monthly or annual pledges at Patreon: https://www.patreon.com/nomadboatbuilding Or make a one time donation: https://www.paypal.com/paypalme/nomadboatbuilding
0
0
0
1,133
