close

Welcome aboard to the our video site for sailors. We are being constantly blasted by scammers and pirates, so registration is  invite only


contact@sailorsahoy.com with "Invite". No spam, no newsletters. Just a free account

শর্টস সৃষ্টি

Esercizio consequenziale per imparare i movimenti di base durante la virata di poppa. lo scopo è quello di far virare la barca passando con il vento da un lato all altro ( mura) mantenendo il contatto visivo .

vitainvela2604

0

0

3,039

Nach einem Problem mit dem Lazybag, in dem sich ca. 200 Liter Wasser gesammelt hatten und daher einige Lazyjacks gebrochen waren, musste Boris nach Südost ablaufen, um mehr Ruhe ins Boot zu bekommen, und verlor dabei 10 Seemeilen. Jetzt ist er aber wieder auf Kurs.

yachttv

0

0

2,118

There were plenty of boats on the star line for the SLYC Two day event, Dark and Scary got slightly to windward of GTR shortly after the start but was slowly burnt off by the superior hight of the J109 GTR. The team at bottom up boats hope you are enjoying some of the best bits from the the 2024 sailing season.

bottomupboats

0

0

3,802

Made out of a bicicle pump! The idea is to use the one way valve that every bicicle pump has on its piston, to improve the performance of the gun, instead of using loose pistons as usually. I know the difference may not be crucial but it's for the sake of well-design. The piston is too heavy but seems to prove the theory. At only 75psi it shoots a 0,2g 6mm plastic bb through a steel (yes, steel. This is Europe) coke can. Filled with water it pierces the can and leaves a mark on the other wall. Air leak detected, soon to be fixed. UPDATE 20150719 Air leak was fixed with teflon tape. Cannon was intended to be tested to 10bar / 145psi. At 8bar / 116psi the back bursted off the main body, propelling it against a wall, with the cannon hitting at a great speed. Result is a bent cannon. Speed doesn't seem to have decreased but precision has been seriously affected. Plans for now are to test the energy at 75psi (like this teaser shows), then cut the cannon to the unbent part (which is about half the lenght), glue the back permanently and test energy again at 75psi to see the relationship between cannon lenglt and muzzle energy. Afterwards, with the back end fully glued, repeat tests at 116psi / 8bar and hopefully get the same energy as full-lenght-cannon @ 75psi. If not, test pressure until total burst, or the desired energy achieved. Advise is greatly appreciated. Thanks for watching! A FewFriendsFace production Likeyright FFF2015 All likes reserved

donotpushhere

0

0

247

zidch1

0

0

893

Maui Oahu matched Old Race Record 5.5 hrs.

hawaiicatamaransailing8187

0

0

29