Giornata della fellowship Rotary e gemellaggio Palermo Marsiglia

0

0

0

24

0

0

0

0

118

Did you know? This nudibranch can give us a lesson. With their slow pace and there is no need to rush, we can savor every moment of our journey and discover the stunning beauty of the underwater world. Care to join us to look for this beautiful nudibranch and some other weird creatures? Save your spot for only from $191! ✉️ info@LaGaligoLiveaboard.com 💬 +62 812 2000 2025 (WhatsApp) 🌐 www.LaGaligoLiveaboard.com 🌐 Trip.LaGaligoLiveaboard.com (Schedule & Rates) ~~~~ #scubadiving #scuba #diving #diver #scubagirl #liveaboard #sea #ship #creatures

0

0

0

1,146

Whether it is right for YOUR wants/needs, solar electric boating is ready for prime time. The electric motors by ​⁠ and ​⁠ are no longer the only options. Couple that with suddenly very affordable and safe lithium iron phosphate, super cheap solar panels and ​⁠ revealing all the how to’s you need and the time truly is NOW.

0

0

0

950

#shorts Coastal Sailing Florida - Life is good on boat. Take a minute to enjoy the scenery and listen to the waves lap against the hull. What would you do to live life stress free? Chat it up in the comments section!

0

0

0

26

Made out of a bicicle pump! The idea is to use the one way valve that every bicicle pump has on its piston, to improve the performance of the gun, instead of using loose pistons as usually. I know the difference may not be crucial but it's for the sake of well-design. The piston is too heavy but seems to prove the theory. At only 75psi it shoots a 0,2g 6mm plastic bb through a steel (yes, steel. This is Europe) coke can. Filled with water it pierces the can and leaves a mark on the other wall. Air leak detected, soon to be fixed. UPDATE 20150719 Air leak was fixed with teflon tape. Cannon was intended to be tested to 10bar / 145psi. At 8bar / 116psi the back bursted off the main body, propelling it against a wall, with the cannon hitting at a great speed. Result is a bent cannon. Speed doesn't seem to have decreased but precision has been seriously affected. Plans for now are to test the energy at 75psi (like this teaser shows), then cut the cannon to the unbent part (which is about half the lenght), glue the back permanently and test energy again at 75psi to see the relationship between cannon lenglt and muzzle energy. Afterwards, with the back end fully glued, repeat tests at 116psi / 8bar and hopefully get the same energy as full-lenght-cannon @ 75psi. If not, test pressure until total burst, or the desired energy achieved. Advise is greatly appreciated. Thanks for watching! A FewFriendsFace production Likeyright FFF2015 All likes reserved

0

0

0

247