Vidéo de bord du 05 novembre 2019 - Jour 9 Durant la Transat Jacques Vabre 2019, suivez le quotidien de Manuel Cousin et Gildas Morvan à bord de l'Imoca Groupe Sétin FRA71.

0

0

0

112

Cocoa Salty Paws takes on her arch rival the Iguana. Want to hang with Cocoa? Join us for a cruise 👉🏽 https://cruisenautic.com/

0

0

0

3,429

Les papates du Girafon Pacific 2018 San Francisco to hawaii Line of Honor . First to finish Figaro Beneteau 3. the first foiler production boat

0

0

0

117

ENDURANCE 35 FT YACHT....Inspecting whether to purchase or not...the decision was yes so we bought the yacht and now comes the next 12 month's or so of renovation...yippy..!

0

0

0

1,554

0

0

0

0

1,693

Have you ever wondered how we get the grain pattern on our bulkheads to match the doors? It’s easy really, our doors are cut out from the bulkheads. Our bulkheads are laminated in place, they are made of two, 15mm thick marine grade plywood panels bonded together, there is also 0.9-1.2mm thick Sapele mahogany veneer on each side. This is the wood you see once the bulkhead is finished and we like it to match the door, perfectly. Before the bulkhead can be fitted, if there is a doorway, it needs to be added. This poses a few problems. Because every boat is individually built, one boat differs from the next so each yacht uses wood from the same tree, and this keeps the colour and grain pattern consistent throughout, but cutting out a door from a bulkhead would cause the bulkhead to flex. Even at over 30mm (1 1/4 in) thick a little flex could cause a problem and make it difficult to close a door once it’s installed. For this reason, we cut out the door, add the laminated Sapele mahogany frame to the bulkhead and 6mm of solid Sapele mahogany around the door and then fit the door into the bulkhead and secure the two together. Only then do we fit the bulkhead into position on the yacht. Once the bulkhead is securely laminated in place, the doors are removed and labelled before varnishing. The doors and the bulkheads are varnished separately. The bulkheads remain unvarnished to allow the GRP laminate and glues that attach the bulkhead to the hull to bond fully with the wood. Once the bulkheads are laminated in place, then they can be varnished, by hand and brush to give a thick, hard-wearing finish. #wearesirius #SiriusWerft #Sirius #siriusyachts #Yacht #Yachting #Sailing #Sailboat #Decksaloon #decksalon #BluewaterCruiser #OffshoreCruiser #LiftingKeel #Twinkeel #BilgeKeel #Handbuilt #Sailingyacht #Sailingboat #BlueWaterSailing #GoAnywhereCruiser #Swingkeel #OceanSailing #Circumnavigation #DreamYacht #Segeln #SailingLife #SailingLifeStyle #LiveABoard #SailingInstagram #YachtingWorld

0

0

0

2,636