As part of IMO's World Maritime Theme "Seafarers: at the core of shippingʹs future" this video series will share the insight and experiences faced by seafarers, reflecting a clear need to raise awareness of seafarersʹ vital role in world trade and increase their visibility.

0

0

0

426

Bavaria 30 Cruiser https://www.scanboat.com/en/17291406 - Bavaria sailing boats: Trusted brand with a wide range of models for every sailing enthusiast - Bavaria sailing boats: Innovative design and advanced technology for optimal performance on the water - Bavaria sailing boats: Spacious interiors and well-designed layouts for comfortable cruising experiences

0

0

0

659

#shorts #gothenburgdiaries #travellife #sweden #varberg

0

0

0

199

Mast raising without a crane sounds a daunting prospect but it is actually very straightforward if you prepare properly. Some years ago I wrote an article which you can see here, https://www.sailingcatamarans.com/index.php/articles/11-technical-articles/268-safe-mast-lowering-method so this is really just an update. This video shows my Chat 18, which has a mast from a beach cat, and thus one that could be pushed up by hand, but here I show the system that works on any size mast - the biggest I have raised this way was on a 50ft ketch. The key features are a good tabernacle, a "gin pole" - in this case the boom - and most important, the use of temporary shrouds thus ensuring that the mast cannot fall sideways. These shrouds must have "chainplates" that line up exactly with the tabernacle pivot bolt. When down the mast rests on a, eg, dinghy trailer mast support at the back of the cockpit. If you regularly raise you mast you can fit a trailer roller to the bracket, so it's easy to push the mast to and fro for trailering. The "gooseneck" for the ginpole is a shroud adjuster from my junk box, suitably bent and screwed to the front of the mast. Roller reefing gear has to be kept straight and has a tendency to catch on the cabin roof etc. So I always lash it to the ginpole in about the right position. The "chainplates" for the temporary shrouds are, again, from my junk box and are 25mm OD aluminium tubes that clip into place and are easily removed. They also take guywires from the forward end of the ginpole to stop that falling over. I attached the spi halyard to the ginpole, but you can just rely on the forestay/furling gear. The mast is then raised up using the mainsheet shackled to the forestay chainplate (you may need a longer rope, depending on your boat). 4:1 is easy on small boats, on bigger boats lead it back to a winch. Of course the most load is when the mast is horizontal, you often have to push on the mast when lowering to get it to start moving. So if you can get it off the support you know you can hoist it all the way. So it all seems a lot of ropes and preparation but it's all worth it as the mast cannot fall and you always have total control, even in a cross wind. And you can usually raise the mast singlehanded. If you are only occasionally raising/lowering the mast then the temporary stays can be rope. Make a loop in the end and pass it over the spreaders and round the mast using a boathook or, on bigger boats, a bosun's chair. Easy to pull off again afterwards. Before sailing always check the mast with binoculars or camera to ensure there are no twisted shackles or, especially, T bar terminals (which is why I don't recommend T bars on trailable boats.) Use tape or elastic band to hold the stays in the correct position while hoisting - both will break away as the shrouds tighten.

0

0

0

2,234

Basta acessar o nosso site https://cotasvelejarevida.com.br/veleiro-scorpio-26-po-pai-73843.html e escolher quantos números você vai querer. Ao final da reserva você pode escolher pagar com o pix que já vai fazer a baixa automática ou pode escolher qualquer outra forma de pagamento e aí você manda o comprovante no whatsapp (11) 98281-9334 ou então pode anexar o comprovante lá no site para darmos baixa manualmente

0

0

0

2,056

Sabre Owner: "Coming into Sydney Harbour from crossing the heads, we had the Gyro going and I was really impressed with the difference it made. We had a 3.5m swell. The boat was stable and handled it incredibly well." ✅ DELIVERS MORE TORQUE IN A SMALLER BOX! The innovative design of the quick gyro delivers more anti-roll talk in a smaller footprint! That means gyro can easily fit in the engine room where it belongs! Do it for you, for your family, and for your soft mates who gets seasick…? ▶ 3000 past customers around the world can't be wrong. 📳Contact the Gineico Marine Team today to discuss the best gyro for your boat, for a better day out! 👉 Book a sea trial today....https://www.gineicomarine.com.au/book-a-sea-trial/ 📍QUEENSLAND HEAD OFFICE & SHOWROOM G45, 76-84 Waterway Drive, Coomera, Qld, 4209 https://www.gineicomarine.com.au/ 👉 AUSTRALIA (+61) 7 5556 0244 👉 NEW ZEALAND (+64) 21 275 7608 👉 EMAIL: Sales@Gineicomarine.com.au

0

0

0

86