Did our friends from CSSC HQ have a good time? Did we? Watch the video.

0

0

0

10

Made out of a bicicle pump! The idea is to use the one way valve that every bicicle pump has on its piston, to improve the performance of the gun, instead of using loose pistons as usually. I know the difference may not be crucial but it's for the sake of well-design. The piston is too heavy but seems to prove the theory. At only 75psi it shoots a 0,2g 6mm plastic bb through a steel (yes, steel. This is Europe) coke can. Filled with water it pierces the can and leaves a mark on the other wall. Air leak detected, soon to be fixed. UPDATE 20150719 Air leak was fixed with teflon tape. Cannon was intended to be tested to 10bar / 145psi. At 8bar / 116psi the back bursted off the main body, propelling it against a wall, with the cannon hitting at a great speed. Result is a bent cannon. Speed doesn't seem to have decreased but precision has been seriously affected. Plans for now are to test the energy at 75psi (like this teaser shows), then cut the cannon to the unbent part (which is about half the lenght), glue the back permanently and test energy again at 75psi to see the relationship between cannon lenglt and muzzle energy. Afterwards, with the back end fully glued, repeat tests at 116psi / 8bar and hopefully get the same energy as full-lenght-cannon @ 75psi. If not, test pressure until total burst, or the desired energy achieved. Advise is greatly appreciated. Thanks for watching! A FewFriendsFace production Likeyright FFF2015 All likes reserved

0

0

0

247

Step aboard this offshore performer bold, powerful, and built for fishing, adventure and leisure. From the Michael Peters designed hull to the sleek T-top and premium helm setup, every inch screams confidence.Watch the full walkthrough now on BoatTEST.com and visit Wellcraft.com to learn more. #BoatTEST #WellcraftBoats #Wellcraft38TTop #Walkthrough #FLIBS #BoatLife #CenterConsole #OffshoreFishing #Powerboat #MichaelPetersDesign

0

0

0

479

Schön, dass du hier bist! Wir, Emely und Tjark, haben uns den Traum vom eigenen Segelboot erfüllt, eine Maxi84, relativ spontan und ohne das ganz große Geld. Das Boot müssen wir noch umtaufen auf den Namen Meera. Wir nehmen dich mit auf unsere Reise von blutigen Anfängern zu hoffentlich passablen Seglern. Bevor wir uns in die Wellen stürzen können, liegt noch ein Berg an Arbeit vor uns. Umbauten, Änderungen und vor allem der Sportbootführerschein müssen erledigt werden. Außerdem müssen wir noch lernen richtig zu segeln. Du kannst dich also schon auf die nächsten Videos freuen! Bei Instagram findest du immer die aktuellsten Infos: https://www.instagram.com/sailingmeera/ Ahoi und viel Spaß mit dem Video ⛵🌊 LIZENZEN/ RECHTLICHES • Musik: https://www.bensound.com/ • Mixkit Stock Music Free License

0

0

0

1,282

0

0

0

0

63

The aluminium plates for the new Bestevaer 53 Motoryacht S.U.V. are being cut at Snijtech in Joure, so that construction can start in August 2019. Keep an eye on our socials or updates!

0

0

0

2,830