Les équipes de NEEL Trimarans ont testé et approuvé durant l’été 2023 le LibertyKite® 40m². Le constructeur renommé de multicoques a ainsi décidé d’équiper en série l’un de ses tout derniers navires, le LEEN 56 de notre kite révolutionnaire arguant : " Cette innovation réduira considérablement votre consommation de carburant tout en offrant une solution de propulsion alternative". Le LEEN 56, équipé de ce Kite, vous permettra de naviguer plus écologiquement et de gagner en autonomie, tout en préservant la performance qui l'a rendu renommée.

0

0

0

1,288

In this short I launch my boat for its maiden voyage. Suddenly disaster strikes. Luckily I was prepared. Plans & Information: https://snipeusa.com/ https://www.snipe.org/ Supplies: Total Boat 5:1 Epoxy: https://amzn.to/3tJJ5H2 Total Boat Penetrating Epoxy: https://amzn.to/3uCo4gP Total Boat Gleam 2.0 Varnish: https://amzn.to/3DipFMG Wire rope/cable: https://amzn.to/3811iaB Swivel Shackle: https://amzn.to/3DiPJHl Crimping Loop Sleeves: https://amzn.to/3uxYb1t Crimping tool: https://amzn.to/36VblO8 Silicon Tube: https://amzn.to/3JPAGaD Tools: Hearing protection: https://amzn.to/3LmsOxL Safety Goggles: https://amzn.to/3wIV5dH Mask/Respirator: https://amzn.to/3wOMBC9 Planer: https://amzn.to/3uC63ir Chisels: https://amzn.to/3uyfRKy Card Scrapers: https://amzn.to/3IHSP8Z Sandpaper Assortment: https://amzn.to/3fWt5c3 Marine Plywood - https://www.boulterplywood.com/ Camera Equipment: Canon SL2 - https://amzn.to/2GPW1ms Tripod - https://amzn.to/2XWVhSd GoPro: https://amzn.to/3tKVjiB

0

0

0

2,811

0

0

0

0

196

0

0

0

0

134

Made out of a bicicle pump! The idea is to use the one way valve that every bicicle pump has on its piston, to improve the performance of the gun, instead of using loose pistons as usually. I know the difference may not be crucial but it's for the sake of well-design. The piston is too heavy but seems to prove the theory. At only 75psi it shoots a 0,2g 6mm plastic bb through a steel (yes, steel. This is Europe) coke can. Filled with water it pierces the can and leaves a mark on the other wall. Air leak detected, soon to be fixed. UPDATE 20150719 Air leak was fixed with teflon tape. Cannon was intended to be tested to 10bar / 145psi. At 8bar / 116psi the back bursted off the main body, propelling it against a wall, with the cannon hitting at a great speed. Result is a bent cannon. Speed doesn't seem to have decreased but precision has been seriously affected. Plans for now are to test the energy at 75psi (like this teaser shows), then cut the cannon to the unbent part (which is about half the lenght), glue the back permanently and test energy again at 75psi to see the relationship between cannon lenglt and muzzle energy. Afterwards, with the back end fully glued, repeat tests at 116psi / 8bar and hopefully get the same energy as full-lenght-cannon @ 75psi. If not, test pressure until total burst, or the desired energy achieved. Advise is greatly appreciated. Thanks for watching! A FewFriendsFace production Likeyright FFF2015 All likes reserved

0

0

0

247

SUBSCRIBE ➡️ http://bit.ly/wsnsubscribe The verdict on the Paris 2024 Windsurfer Equipment and the Governance Reform Proposal, as World Sailing's Annual Conference concluded in Bermuda with the Annual General Meeting. Follow World Sailing 🌍⛵️ on: Facebook ➡️ www.facebook.com/worldsailingofficial Instagram ➡️ www.instagram.com/worldsailingofficial Twitter ➡️ www.twitter.com/worldsailing Website ➡️ www.sailing.org Newsletter ➡️ bit.ly/wsezine

0

0

0

485