Join us on a spirited sailing adventure from Ragged Island to George Town, Bahamas on a Nautitech 46 Open catamaran. We had an awesome week down in the Raggeds. We had East winds for the entire week, allowing for some pretty fun sailing....for all but the last day when we sailed to Flamingo Cay to the south side of Hog Cut. It's important to pay attention to how the Raggeds bend to the east! We didn't and ended up needing to tack up to Hog Cut....best to make the trip if the winds are greater than 110º or more. #sailinglife #catamaransailing #nautitech46open

0

0

0

578

The servo is hooked up to the Arduino via pin 9. I've uploaded one of the example sketches you get with Arduino ISP called 'Servo Sweep'. The servo is powered by a 24 volt rough DC supply as you can see in the video. The 20mm steel boss was machined and bored out concentrically to 8.0 mm. A 5.0 mm hole was drilled in the side of the boss and tapped to take an M6 grub screw. The boss was welded into a piece of 1/8 inch steel plate to make the servo arm.

0

0

0

855

0

0

0

0

251

Solus Alta https://www.scanboat.com/en/17431661

0

0

0

304

Sailing wisdom revealed: When to reef isn’t just a rule—it's a feel. 🚤✨ The more you sail, the more your instincts will guide you. Trust your experience and know when it’s time to reef. 🌬️🌊 #catamaranbook #NEELtrimarans #Nautitechcatamarans #McConaghyBoats #multihulls #shorts

0

0

0

3