Welcome aboard to the our video site for sailors. We are being constantly blasted by scammers and pirates, so registration is invite only
contact@sailorsahoy.com with "Invite". No spam, no newsletters. Just a free account
Shorts skab
1. Remove the old caulking. We use a special tool from @teakdeckingsystems. 2. If your deck is both screwed and glued, considwe removing the screws. We chose to remove the screws since they only created a possibility for water to enter the construction. 3. Fill out every screw hole with epoxy. During the renovation, we learned it would be a good idea to fill the holes with epoxy as soon as you remove the screws to ensure you seal every single hole. 4. Route between all the teak strips. We routed all the way to the gel coat to have as much wood to work with as possible. We used a fine cutter where the caulking was across the grain. 5. Seam sanding. It helps remove the remaining caulking and gives the teak a fresh bonding surface. 6. Masking the teak strips. We chose to mask the wood to reduce the sanding process later on because we knew the teak wasn’t very thick. 7. Cleaning off with acetone. This helps remove dust and gives the caulking the best conditions to adhere to the wood and cure. 8. Start caulking. We used an air compressor caulking gun. It makes the process easier for large surfaces that need caulking - we used SIS 440 from @teakdeckingsystems. We also used a 3D-printed applicator for the caulk head, which minimizes the amount of caulking used. I could only find it on @hfindustrimarineaps website. 9. “Spoon” caulk further into the seams. We used a flexible putty knife to smoothing the caulking. 10. Pull off the masking. While removing the tape, we used scissors to cut just before the area where it hadn’t been caulked yet. 11. Remove the top of the caulking. We used a sharp stanley knife. We did this to minimize sanding, just as we did with masking. 12. Sanding with grit 80. We used the fine cutter’s sanding head for all the edges and an orbital sander for the larger areas. Side note: Sanding with grit 40. We believe the best way is to sand before routing to even out the wood. Unfortunately, we had many places where the wood was so worn out that it wouldn’t have been possible to follow the old tracks with the router after sanding. #diy #sailing #sailingdiy #teak #teakdeck #sailingdenmark #boatwork #shortoftheday
Desde la frescura de los mariscos hasta el chisporroteo en la parrilla, en El Velero llevamos la pasión por la cocina a otro nivel. 🍽️ Sabor, tradición y técnica en cada preparación. Texturas, aromas y el toque perfecto de fuego. ¿Listo para disfrutarlo? 🤩 ¡Ven y vive la experiencia El Velero! #SaborDelMar #CocinaConPasión #ExperienciaElVelero #ParrilladaDeMariscos
J109 GTR beating up the shore to stay out of the tide shortly after the start of the Harbour Race of Cork Week 2024. With over 100 boats on the start line everyone was fighting for air shortly after the start, with the tide coming in all day it paid to get right early to find both clear air and some relief from the stronger tide out in the main channel. The skipper on RS 21 Dark and Stormy was not happy with the call as they wanted to head in further, we are glad they tacked when they did as we got down to less the 3 feet under the keel shortly after the tack. The team at Bottom Up Boats hope you like this short clip from our week of racing at Volvo Cork Week 2024