CATANA OC 2 – NOUVEAU MILLÉSIME Une nouvelle ère de confort en mer. Des lignes plus affûtées. Des espaces réinventés. Chaque détail pensé pour vous. OC 2, c’est l’alliance parfaite entre performance, innovation et art de vivre. Une expérience à vivre dès maintenant en vidéo. 🎥 Découvrez la vidéo complète ici : https://youtu.be/yzF0lMz44gs 📍 Avant-première au Salon de Cannes 2025 👉 Prenez rendez-vous : https://www.catana.com/event/cannes-yachting-festival/ CATANA OC 2 – A NEW GENERATION A bold new vision of life at sea. Sharper design. Smarter spaces. Every detail refined for you. OC 2 blends performance, innovation, and lifestyle like never before. Dive into the experience—now in video. 🎥 Watch the full video here: https://youtu.be/yzF0lMz44gs 📍 World premiere at the 2025 Cannes Yachting Festival 👉 Book your appointment: https://www.catana.com/en/event/cannes-yachting-festival/

0

0

0

72

Made out of a bicicle pump! The idea is to use the one way valve that every bicicle pump has on its piston, to improve the performance of the gun, instead of using loose pistons as usually. I know the difference may not be crucial but it's for the sake of well-design. The piston is too heavy but seems to prove the theory. At only 75psi it shoots a 0,2g 6mm plastic bb through a steel (yes, steel. This is Europe) coke can. Filled with water it pierces the can and leaves a mark on the other wall. Air leak detected, soon to be fixed. UPDATE 20150719 Air leak was fixed with teflon tape. Cannon was intended to be tested to 10bar / 145psi. At 8bar / 116psi the back bursted off the main body, propelling it against a wall, with the cannon hitting at a great speed. Result is a bent cannon. Speed doesn't seem to have decreased but precision has been seriously affected. Plans for now are to test the energy at 75psi (like this teaser shows), then cut the cannon to the unbent part (which is about half the lenght), glue the back permanently and test energy again at 75psi to see the relationship between cannon lenglt and muzzle energy. Afterwards, with the back end fully glued, repeat tests at 116psi / 8bar and hopefully get the same energy as full-lenght-cannon @ 75psi. If not, test pressure until total burst, or the desired energy achieved. Advise is greatly appreciated. Thanks for watching! A FewFriendsFace production Likeyright FFF2015 All likes reserved

0

0

0

249

Global Surveyor sailing from the South Shetlands to West Antarctic Peninsula, January 2023.

0

0

0

1,669

A lone manta ray at Wai island. Aerial footage by Rob from Coralia Liveaboard.

0

0

0

29

0

0

0

0

357