Lovely ride today with the Santa Rosa Cycling Club (SRCC) Friendly Friday B group. see the course and stats at: http://ridewithgps.com/trips/1126955

0

0

0

55

0

0

0

0

526

Planning your private escape on the waters of Dubai?🏝️🛥️ Explore with us at Boat Trips Dubai!!! YachtLife #BoatTripsDubai #YachtWalkthrough #DubaiMarina #LuxuryYacht #DubaiYacht #YachtTour #DubaiAdventures #SailDubai #YachtVibes #LuxuryOnWaves #BoatLife #ExploreDubai #SailingInDubai #DubaiDreams #ReelItFeelIt #InstaYacht #VlogDubai

0

0

0

14

The Takacat 340 Explorer is very easy to use, you can basically launch and retrieve any where with one person. The stability from the unique catamaran design is amazing and provides a very safe and stable fishing platform. Different from most inflatable boats the unique bow design with no inflatable tube is ideal for bring in the big ones (not shown in this video). With the shallowest draft of any boat of it's size as well as brilliant sea handling, you can be fishing in the shallows, close into pinnacles, rocks and reefs or out in the rough. the choice is your as this design opens up a lot of different fishing location options. Only available from: http://www.takacat.com http://www.takacat.se http://www.takacat.us

0

0

0

4,035

The idea behind it is that it hangs onto thin veneers that may otherwise flutter against the tablesaw blade as it reaches the end of the cut. There are other methods for cutting thin veneers which you can explore on YouTube. I find this helpful because it hangs onto the finished veneer as I tend to the billet it just came off. It is also helpful in that it is a one-fence-setting system, unlike cutting veneers off the outboard face of the blade. Of course a fresh push stick is a good idea as is a zero clearance throat plate in your saw. For most standard table saws, that is a simple project in itself. I have a pattern that allows me to make new ones easily. Subject for another video. The extended backboard allows me to fasten this jig to my Jim Tolpin style fence extension. Detail of that can be found in Jim Tolpin’s Tablesaw Magic book. A worthwhile read in its own right. You could eliminate the backboard and recess the end caps allowing f-body clamps to reach in and hold it to any tablesaw fence. I’ll leave other solutions to your own innovation. I use this jig with a Fein shop vac which has a volume control. I was surprised how low I had to turn it down to prevent the stock from locking itself firmly onto the fence, preventing me from feeding it through the blade. You may have to increase the number of saw kerfs through the front of the fence until you find the sweet spot for your vacuum. I would do it one kerf at a time. Note that the kerfs pass all the way through the fence face such that they are exposed on the ends. That is to allow the air to pass behind the stock. I hope this is useful to some of you. Happy wood butchering folks.My website: https://www.nomadboatbuilding.com Instagram: https://www.instagram.com/nomadboatbuilding/ It's not about the money but living isn't free... Products featured in this video: Buy some merch: https://www.nomadboatbuilding.com/shop/ Support these videos with monthly or annual pledges at Patreon: https://www.patreon.com/nomadboatbuilding Or make a one time donation: https://www.paypal.com/paypalme/nomadboatbuilding

0

0

0

1,145

Isuzu 2AB1 Diesel Engine Rebuild getting everything cleaned and prepped right!

0

0

0

1,281