a new exterior design from RWD and interior collaboration with Valentina Zannier. At the essence of her design lies the perception of space: volumes that embrace, proportions that inspire, and a feeling of welcome that defines a new lifestyle at sea.

0

0

0

90

Video from Michael Delegarza & Peter Geerlofs

0

0

0

434

The porch light is officially a memory and the lawn mower is someone else’s problem now. We traded the deafening silence of a big, empty house for a salt breeze and a view that actually matters. ​The kids are grown, the nest is empty, and my babe finally found her "happy hour" headquarters between the palms and the trees. We aren't just retiring; we're escaping. If you’re tired of the "too quiet" house and ready to find your own flight, welcome to the ride. It’s a little bit of salt, a whole lot of freedom, and absolutely zero regrets. ​Living for the breeze, not the grass. ​#EmptyNest #SailingLife #CoastalLiving #Freedom #NewChapter #Cheers

0

0

0

0

0

0

0

0

1,268

Fuerteventura per noi ha avuto un gusto dolce e amaro. La prima volta sono arrivata ero incinta con Valerio e Leilani ed il mio primo pensiero è stato "Ma cosa ci trova la gente di tanto bello in questo posto?!" Abusi edilizi, mantenimento delle aree urbane non proprio eccellente per non dire altro... Eppure dopo solo tre giorni fra deserto, pietraie, vulcani e spiagge infinite dove volendo puoi non incontrare nessuno per km, quest'isola mi ha letteralmente rapito il cuore. Una chiamata a Fabio che fortunatamente si fida ciecamente di me e comincio a cercare casa...ma nulla nonostanete le nostre soventi visite, la bella Fuerte non ci ha voluti... almeno per il momento. Ma non tutto capita per caso ed infatti ad oggi eccoci qui con una nuova barca e tanti progetti nella testa! Raccontiamo qualcosa di Fuerte nel video su YT Ci sono dei posti che semplicemente ti rimangono dentro ma non sai bene il perchè... mi piacerebbe sapere il vostro! #vivereinbarca #famigliainbarca #fuerteventura

0

0

0

727

Made out of a bicicle pump! The idea is to use the one way valve that every bicicle pump has on its piston, to improve the performance of the gun, instead of using loose pistons as usually. I know the difference may not be crucial but it's for the sake of well-design. The piston is too heavy but seems to prove the theory. At only 75psi it shoots a 0,2g 6mm plastic bb through a steel (yes, steel. This is Europe) coke can. Filled with water it pierces the can and leaves a mark on the other wall. Air leak detected, soon to be fixed. UPDATE 20150719 Air leak was fixed with teflon tape. Cannon was intended to be tested to 10bar / 145psi. At 8bar / 116psi the back bursted off the main body, propelling it against a wall, with the cannon hitting at a great speed. Result is a bent cannon. Speed doesn't seem to have decreased but precision has been seriously affected. Plans for now are to test the energy at 75psi (like this teaser shows), then cut the cannon to the unbent part (which is about half the lenght), glue the back permanently and test energy again at 75psi to see the relationship between cannon lenglt and muzzle energy. Afterwards, with the back end fully glued, repeat tests at 116psi / 8bar and hopefully get the same energy as full-lenght-cannon @ 75psi. If not, test pressure until total burst, or the desired energy achieved. Advise is greatly appreciated. Thanks for watching! A FewFriendsFace production Likeyright FFF2015 All likes reserved

0

0

0

247