Join us on the self-guided;) Tour of this 1999 Navigator 5300 Motor Yacht Affordable Yacht. She would make a great Liveaboard Boat for a single, couple, or a small family - just add your personal touches, a little TLC and she is ready to cruise the Caribbean! She is currently listed for sale for $219,900. Enjoy the Tour! 😜 Let me know what you guys think of this one in the comments #Liveaboard #YachtTour #MotorYacht

0

0

0

622,502

0

0

0

0

683

Eine erfolgreiche Reparatur für wenige 100 Euro statt eines teuren Motoraustauschs! Erfahre, wie du Geld sparen kannst. Alle Tipps, Analyse, Reparatur und Lösung dazu im Hauptvideo. #Reparatur #Motoraustausch #Belüfter

0

0

0

2,287

Hey everyone, here's a peak at what's coming up in the next episode.

0

0

0

16,128

Full video - Just the two of us! We're a sailing couple, on Lewisville Lake, Texas, and we do love to be anchored in the cove and cook on the grill. We determined what needed to be done with the water leak on the boat, and when we get back to the marina we head to West Marine for boat parts! #lakecruise #sailingcouple #catalina30 #sailing #sailboat #piratelife

0

0

0

0

Screwhead teak plugs in 23 seconds!! Having just replaced around 1000 teak screw head plugs…this was the process.. Unscrew every exposed screw: I used a battery drill driver. Drill the hole deeper: I used a 10mm forstner bit as it fitted the existing holes perfectly and did a tidy job. This is subject to having enough teak left to drill deeper. Fortunately Najad were generous with their teak! Try not to drill as far as the fibreglass. Add sealant and replace the screws: I’ve seen videos where they say the screws were just for construction and you can leave them out. That is probably correct but I’m going for better safe than sorry. If the teak was thinner with no room to drill deeper and replace the screws I’d leave them out as a last chance of getting a few more years out of a worn deck. Sealant to stop any water getting into the deck core. I used a hand screwdriver rather than power to replace them as power was tending to rip out the self tapping screws from the fibreglass. Put glue on the plug: I used a polyurethane foaming wood glue. Epoxy would be very strong but mixing all the batches a big pain if you have lots to do. Try to get more glue on the edges than the base of the plug as I had a couple of plugs pushed out as the glue foamed up. Tap in the plug: I used a standard claw hammer as it’s all I had but I daresay a wooden mallet is recommended but the top of the plug is waste material anyway so it matters not. Cut off the excess: I used a Fein multi tool oscillating saw. Be careful with your angle as you don’t want to gouge the surrounding deck. It took me a few goes to master the technique but was pretty quick when I did. I said the top of the plugs were waste but if you found yourself short a lot of them had enough material left to do more holes. Sand flat: I used a random orbit sander with a worn 80 grit pad. I now have fresh patches all over the deck so, once I’ve completed a couple of caulking touch ups, I’ll give the whole deck a very light sanding. You could just leave the newly sanded plug patches to grey down to match the deck if you preferred. And that’s it…repeat many times! Feel free to ask any questions 😊⛵️ #boatlife #liveaboardsailboat #boatmaintenance #najad #boatrepairs

0

0

0

696