最新の動画
Tape stuck onto a piece of borosilicate glass Printing done with 110 deg bed.
0
The servo is hooked up to the Arduino via pin 9. I've uploaded one of the example sketches you get with Arduino ISP called 'Servo Sweep'. The servo is powered by a 24 volt rough DC supply as you can see in the video. The 20mm steel boss was machined and bored out concentrically to 8.0 mm. A 5.0 mm hole was drilled in the side of the boss and tapped to take an M6 grub screw. The boss was welded into a piece of 1/8 inch steel plate to make the servo arm.
0
With cousins Jorge y Sofia
BGS Annual Dance Show Feb 2016
BGS Annual Dance Show Feb 2016
Hampton half marathon Feb 2016
0
Worse than 2003
0
0
Sat 8 June 2013 Off Hayling Island
Mary crosses finish line 1h59
Sledging at Taplow Rec Jan 2013 Ash and James
This video was uploaded from an Android phone.
This video was uploaded from an Android phone.
This video was uploaded from an Android phone.
This video was uploaded from an Android phone.
