Full video just went live! AND Now We're Going Back... 👉 https://youtu.be/kYW2xh83GYk

0

0

0

1,072

0

0

0

0

66

Screwhead teak plugs in 23 seconds!! Having just replaced around 1000 teak screw head plugs…this was the process.. Unscrew every exposed screw: I used a battery drill driver. Drill the hole deeper: I used a 10mm forstner bit as it fitted the existing holes perfectly and did a tidy job. This is subject to having enough teak left to drill deeper. Fortunately Najad were generous with their teak! Try not to drill as far as the fibreglass. Add sealant and replace the screws: I’ve seen videos where they say the screws were just for construction and you can leave them out. That is probably correct but I’m going for better safe than sorry. If the teak was thinner with no room to drill deeper and replace the screws I’d leave them out as a last chance of getting a few more years out of a worn deck. Sealant to stop any water getting into the deck core. I used a hand screwdriver rather than power to replace them as power was tending to rip out the self tapping screws from the fibreglass. Put glue on the plug: I used a polyurethane foaming wood glue. Epoxy would be very strong but mixing all the batches a big pain if you have lots to do. Try to get more glue on the edges than the base of the plug as I had a couple of plugs pushed out as the glue foamed up. Tap in the plug: I used a standard claw hammer as it’s all I had but I daresay a wooden mallet is recommended but the top of the plug is waste material anyway so it matters not. Cut off the excess: I used a Fein multi tool oscillating saw. Be careful with your angle as you don’t want to gouge the surrounding deck. It took me a few goes to master the technique but was pretty quick when I did. I said the top of the plugs were waste but if you found yourself short a lot of them had enough material left to do more holes. Sand flat: I used a random orbit sander with a worn 80 grit pad. I now have fresh patches all over the deck so, once I’ve completed a couple of caulking touch ups, I’ll give the whole deck a very light sanding. You could just leave the newly sanded plug patches to grey down to match the deck if you preferred. And that’s it…repeat many times! Feel free to ask any questions 😊⛵️ #boatlife #liveaboardsailboat #boatmaintenance #najad #boatrepairs

0

0

0

697

Korčula, the fabled birthplace of the renowned explorer Marco Polo, is named affectionately by some as 'Little Dubrovnik'. And once you gaze at walls and towers of Korčula Old Town it’s quite easy to see why. If you're planning on visiting the impressive Old Town, fishbone-shaped streets and incredible bars, restaurants, and cafes of Korcula, here are our top things to do: 1. Sip on a cocktail as the sun sets at Massimo Cocktail Bar 2. Walk the steps into Korcula Old Town and take in the Revelin Tower 3. Discover the impressive architecture at St. Peter's Church 4. Step back in time at the Large Governors Tower 5. Climb the bell tower for impressive views at St. Mark's Cathedral; the highest point in Korcula Old Town For a complete guide on what to do, see, eat and drink in Korcula, see our comprehensive Destination Guide here: https://www.sail-croatia.com/set-sail/destination/korcula

0

0

0

1,830

Thirty hours into the 74th edition of the Rolex Sydney Hobart Yacht Race, the four 100-ft Maxis at the front of the fleet were separated by a mere five-nautical miles with a little under 200-nautical miles still to complete. A close contest between the race leaders has ensued ever since yesterday’s memorable Sydney Harbour start. Although the race record is unlikely to be challenged, an exciting finale down the Derwent River into Hobart is forecast. There had been four retirements and the majority of the 81-strong fleet were negotiating the Bass Strait. Rolex has been Title Sponsor of the 628-nm race, organised by the Cruising Yacht Club of Australia with the collaboration of the Royal Yacht Club of Tasmania, since 2002.

0

0

0

52,239

Follow Team Brunel: #teambrunel http://www.brunelsailing.net https://twitter.com/brunelsailing https://www.facebook.com/brunelsailing https://www.instagram.com/brunelsailing/ https://www.youtube.com/user/TeamBrun... A Magenta Films production http://www.magenta-films.com

0

0

0

1,126