close

Welcome aboard to the our video site for sailors. We are being constantly blasted by scammers and pirates, so registration is  invite only


contact@sailorsahoy.com with "Invite". No spam, no newsletters. Just a free account

Shorts Lumikha

Freebird Catamarans customer reviews. Just a few minutes from your hotel you can enjoy the best whales and dolphins watching excursion in Tenerife. In Freebird Catmarans you can book an excursion of 3 hours around Costa Adeje area, and an excursion of 4 hours ½ to Los Gigantes Cliffs and Masca.

freebirdcatamaranwhalewatc5836

0

0

210

Check out the link below for full instructions on how to tie the Highwayman's Hitch. https://youtu.be/USjyE1nTV9Q The Highwayman’s hitch is a quick-release draw hitch used for temporarily securing a load that will need to be released easily and cleanly. The hitch can be untied with a tug of the working end, even when under tension. The highwayman's hitch can be tied in the middle of a rope, and so the working end does not need to be passed around the anchor when tying or releasing. The knot is three bights that each successively lock the previous one: - The first one, in the middle of the rope, wraps around the pole, - The second one (called the toggle bight) is a bight of the standing part locking the first one so the pole is held tight, and - The third one (called the slip-tuck) is a bight of the working part (slack end) locking the second bight. The locking actions are achieved by reaching through each bight to pull the next one through. The knot has to be finished by pulling the standing part tight to ensure that it holds. Until the knot is tightened and properly dressed, the highwayman's hitch has little holding power. The highwayman's hitch is susceptible to capsizing when the pole is substantially larger than the rope diameter. The failure occurs because the second bight sees the force of the standing part, but is held in place by the working part, which has no tension. When capsizing, tension on the standing part pulls the second bight through the first bight. This drags the slip-tuck through, and will release the hitch if the third bight isn't long enough. The team at bottom up boats hope you enjoyed our latest video demonstration where we teach you how to tie the highwayman's hitch.

bottomupboats

0

0

71,540

74m. Built by @amelsyachting and filmed by @breedmediacreative Exterior Design by @thdinst and Interior Design by @winchdesign_wd

spinnakermagazine

0

0

52

Cabins are NOW OPEN! It only takes two of you. Grab yours here: www.theyachtweek.com/cabins

theyachtweek

0

0

410,732

XO 250 in action outside Helsinki. Filmed with heli-cam. Aluminium deep 24 degr. V- hull. 1,5 ton and 44 knots with Honda 250 hp. With 300 hp top speed up to 50 kn and economical cruising in 35 knots.

xoboats334

0

0

11,762

0

daliaveleiroclassico9202

0

0

295