
Kossel running Klipper first print with default settings.
0
0
71 Bekeken·
12/02/24
In
Zeilboten
This is my almost 11yr old Kossel, originally created as a "Rostock" with woodwn base and top plates and steel rods. A lot changed ober the years until now as you might see? Kossel running with a SKR 1.4 board and a RPi 3. No special settings or configuration was done printing this part in PETG. This results in this print being far away from perfect? but for the first print, I think it's not too bad
Laat meer zien

0 Comments
sort Sorteer op