পরবর্তী আসছে

Kossel running Klipper first print with default settings.

71 ভিউ· 12/02/24
marsten3982
marsten3982 (@marsten3982)
সাবস্ক্রাইবার
0

This is my almost 11yr old Kossel, originally created as a "Rostock" with woodwn base and top plates and steel rods. A lot changed ober the years until now as you might see? Kossel running with a SKR 1.4 board and a RPi 3. No special settings or configuration was done printing this part in PETG. This results in this print being far away from perfect? but for the first print, I think it's not too bad

আরো দেখুন

 0 মন্তব্য sort   ক্রমানুসার


পরবর্তী আসছে