1,353 Bekeken · 08/07/25
83,083 Bekeken · 17/05/25
32,682 Bekeken · 12/05/25
821 Bekeken · 20/04/25
3,700 Bekeken · 12/04/25
129,935 Bekeken · 12/04/25
16,635 Bekeken · 07/04/25
2,143 Bekeken · 14/03/25
![BOAT FAIL: we ran out of FUEL! (after sailing 1000 miles) [Ep168 RED SEAS]](https://i.ytimg.com/vi/fzW3DYgMJsw/maxresdefault.jpg)
6,569 Bekeken · 02/03/25
118,843 Bekeken · 23/02/25
13,779 Bekeken · 21/02/25
1,484 Bekeken · 16/02/25
Bambi labs print failed, slicer showed me it was going to fail
0
0
40 Bekeken·
28/02/24
In
Zeilboten
I printed a model downloaded from thingyverse and the slicer showed white bits which I ignored :(. So of course the print failed. I adjusted some layer heights and the slicer showed the white lines had gone and it printed fine.
Laat meer zien
0 Comments
sort Sorteer op
1,353 Bekeken · 08/07/25
83,083 Bekeken · 17/05/25
32,682 Bekeken · 12/05/25
821 Bekeken · 20/04/25
3,700 Bekeken · 12/04/25
129,935 Bekeken · 12/04/25
16,635 Bekeken · 07/04/25
2,143 Bekeken · 14/03/25
6,569 Bekeken · 02/03/25
118,843 Bekeken · 23/02/25
13,779 Bekeken · 21/02/25
1,484 Bekeken · 16/02/25
