1,353 Visninger · 08/07/25
2,235 Visninger · 18/05/25
83,083 Visninger · 17/05/25
32,682 Visninger · 12/05/25
821 Visninger · 20/04/25
3,700 Visninger · 12/04/25
129,935 Visninger · 12/04/25
16,635 Visninger · 07/04/25
21,688 Visninger · 28/03/25
2,143 Visninger · 14/03/25
![BOAT FAIL: we ran out of FUEL! (after sailing 1000 miles) [Ep168 RED SEAS]](https://i.ytimg.com/vi/fzW3DYgMJsw/maxresdefault.jpg)
6,569 Visninger · 02/03/25
118,843 Visninger · 23/02/25
13,779 Visninger · 21/02/25
1,484 Visninger · 16/02/25
Bambi labs print failed, slicer showed me it was going to fail
0
0
40 Visninger·
28/02/24
I
Sejlbåde
I printed a model downloaded from thingyverse and the slicer showed white bits which I ignored :(. So of course the print failed. I adjusted some layer heights and the slicer showed the white lines had gone and it printed fine.
Vis mere
0 Kommentarer
sort Sorter efter
1,353 Visninger · 08/07/25
2,235 Visninger · 18/05/25
83,083 Visninger · 17/05/25
32,682 Visninger · 12/05/25
821 Visninger · 20/04/25
3,700 Visninger · 12/04/25
129,935 Visninger · 12/04/25
16,635 Visninger · 07/04/25
21,688 Visninger · 28/03/25
2,143 Visninger · 14/03/25
6,569 Visninger · 02/03/25
118,843 Visninger · 23/02/25
13,779 Visninger · 21/02/25
1,484 Visninger · 16/02/25
